Dell PowerEdge M620 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Interruptor Dell PowerEdge M620. Dell PowerEdge M620 26 páginas. Dell poweredge blade servers getting started guide
Também para Dell PowerEdge M620: Atualização da informação (38 páginas), Notas de lançamento (27 páginas), Manual (25 páginas), Manual do utilizador (23 páginas), Manual de informações importantes (35 páginas), Manual de atualização (32 páginas), Manual de atualização (28 páginas), Manual do utilizador (22 páginas), Manual de iniciação (12 páginas), Manual de iniciação (12 páginas), Manual técnico (46 páginas), Manual técnico (49 páginas), Manual da carteira (27 páginas), Manual técnico (44 páginas), Manual de iniciação (14 páginas), Manual de iniciação (12 páginas)

Dell 10Gb Ethernet Pass Through II

Overview

This manual explains the use of the embedded software management of the 10GbE PTM. It

explains how to connect to the 10GbE PTM and to the CMC, and how to update the module and

device firmware and software.

This manual covers the following topics:

• The rest of this section provides a high-level overview of the I/O Module structure and capabili-

ties

•

Section 2, "Connecting to the 10GbE PTM CLI," on page

10GbE PTM and issue CLI commands

•

Section 3, "Command Line Interface (CLI) Reference," on page 12

•

Section 4, "Operating Procedures," on page 19

required to achieve tasks such as software update

1.1

The 10GbE PTM has 16 front panel ports divided into two groups: A and B. Group A consists of

ports 1 through 8, providing service to blades 1 through 8, respectively; Group B consists of ports

9 through 16, providing service to blades 9 through 16, respectively.

The supported link protocol for all ports is 10GigE XAUI (KX4)

Figure 1 shows the front panel ports and their partitioning into Group A and Group B.

10 Gb Ethernet Pass Through II

1.2

The 10GbE PTM reflects the link state from the uplink to the downlink. When an uplink port con-

nected to a remote peer (e.g. an Ethernet switch) is disconnected, the respective server blade will

indicate link down event. When the uplink port is connected, the respective server blade will indi-

cate link up.

1.3

A port may enter a link protocol mismatch condition. When in this condition, the port links (both

uplink and downlink) will remain inactive. Mismatch condition is indicated by the port LEDs.

Additional information about the mismatch condition is available via the CLI. Link protocol mis-

match would occur under the following conditions:

Figure 1: Front Panel Link Speed Port Groups

8, explains how to connect to the

documents the CLI

describes the detailed sequence of operations

Rev 1.00