Entec Solar E-1000 Manual de início rápido - Página 9

Procurar online ou descarregar pdf Manual de início rápido para Instrumentos de medição Entec Solar E-1000. Entec Solar E-1000 17 páginas.

Entec Solar E-1000 Manual de início rápido

4 General recommendations

The interface of the E-1500 / E-1000 is designed based on rectangles as buttons.
You may press the desired button to use the associated function.
There are functions, like for example "Autosave", that when they are pressed they
change the background to the red color. This means that the function is active. Press
on it again to disable it and the color will change to blue.
When numbers are introduced to set up a parameter, all the gaps must be filled,
even if the value of them are zero.

5 Quick Start Guide

5.1 Configuration previous to the measurements
It is strongly recommended to fully read the manual before proceeding with the mea-
surements and check the corresponding section in case of doubt.
1. Turn on the device.
2. Check that the battery levels of the devices are correct as well as the SD cards are
all in place. (Section 4.2 and 4.3).
3. Place the radiation and temperature sensors in a location that is representative of
the circuit under test and make sure that the calibration cell is on the same plane as
the solar cell. Also make sure you make no shadow on the solar cell.
4. Connect the reference cell, as well as all the PT1000 used to the corresponding
channel inputs.
5. Connect the barcode scanner to the device (optional) (Section 5.5.10)
9
"Innovative technological developments for the solar photovoltaic industry"
www.entecsolar.es