EarthQuake T1000W/2 Manual do Proprietário - Página 6

Procurar online ou descarregar pdf Manual do Proprietário para Amplificador EarthQuake T1000W/2. EarthQuake T1000W/2 8 páginas. Earthquake ph10000w/d1: product brochure
Também para EarthQuake T1000W/2: Brochura (8 páginas)

EarthQuake T1000W/2 Manual do Proprietário

T2000W/4

HIGH LEVEL
LEVEL ADJUST:
INPUT:
Allows the amplifier to deliver a controlled
Speaker level
maximum sound level into selected
inputs with a
channel(s) when the volume is turned to
range of 0.5V
max. This acts as a volume limiter for the
to 17V RMS.
system, preventing you from over driving
the speakers or subwoofers.
AUTO ON
RESET
REMOTE ON
LOW LEVEL INPUTS:
AUTO SIGNAL
Low level inputs
with a
SENSING:
range of 0.2V to 7V RMS.
Please refer to page 3 for
This is where the front and
e x p l a n a t i o n o f t h i s
rear RCA outputs from your
feature.
head unit or other devices
are inserted.
The gain knob is not a volume
control. It is designed to match
the input level of the amp to the
output level of the source unit.
Over driving "clipping" the input
stage of the amp will cause
damage to the amplifier (please
refer to table for setting).
Bridgeable Speaker
outputs, minimum
4-Ohms mono.
10
Specifications Are Subject To Change Without Notice
This information applies to
both channels 1/2 and 3/4
MODE SELECTOR:
2-WAY 12dB/Oct
This feature tells the
VARIABLE XOVER:
amplifier to run in
C o n t r o l
t h e
either HIGH PASS,
corresponding channels
FULL RANGE or
cutoff frequencies. This
LOW PASS MODE
feature is disabled when
in FULL RANGE
BASS BOOST:
PROTECTION (PROT) LED:
0 - 18dB Bass
If LED comes on then you have an
Boost for use
issue that requires service. Turn
w
i
t
h
off the amplifier and call
subwoofers.
Earthquake for further assistance.
See warranty for details.
XOVER
KNOB
SETTING
50Hz
90Hz
125Hz
170Hz
T2000W/4
MAX INPUT
VOLTAGE
BEFORE
CLIPPING
7.0V
4.0V
2.5V
RCA LEVEL
SPEAKER
17.0V
10.0V
5.0V
LEVEL
To car chassis / ground
Two
20A
To remote turn on / trigger
fuses
To battery positive (+)
R C A
l i n e
t h r o u g h t o
c a s c a d e
a n o t h e r
amplifier.
N o
X o v e r
point.
Set Xover switch
to FULL
POWER LED:
When LED is on, it
indicates that the
amplifier is ON and
f u n c t i o n i n g
properly.
210Hz
250Hz
1V
1V
FC6.2 Midrange
FC6.2 Midrange
FC6.2 Xover FC6.2 Xover
CH1
CH2
FC6.2
FC6.2
Tweeter
Tweeter
CH3
CH4
FC6.2 Midrange
FC6.2 Midrange
FC6.2 Xover FC6.2 Xover
FC6.2
FC6.2
CH1
CH2
Tweeter
Tweeter
CH3
CH4
K-10, ten-inch bass tube, in mono
application (4 Ohms minimum)
www.earthquakesound.com
11