EarthQuake 9800 Series Manual do operador - Página 4
Procurar online ou descarregar pdf Manual do operador para Equipamento para relva e jardim EarthQuake 9800 Series. EarthQuake 9800 Series 13 páginas. Two-man earth auger powerhead
Também para EarthQuake 9800 Series: Manual do operador (16 páginas), Manual do operador (19 páginas), Manual do operador (20 páginas)
Imprimir página
ARDISAM
REGISTRATION FORM
Complete and return. Your auger has a serial number
decal located on side of engine directly above the
carburetor. Record this number and the model number in
the space provided on page 3 of this manual. You will need
these numbers if you order parts. Fill out and mail the
registration card located in your parts packet. Warranty is
valid only if your completed registration card is received by
Ardisam, Inc., at time of purchase.
SPARK PLUG INSTALLATION
If your powerhead does not have the spark plug already
installed for you. You will have to install it following the
instructions given below.
1. Locate the spark plug in the parts packet.
2. With powerhead laying on side labeled "THIS SIDE UP
WHEN NOT IN USE," place spark plug in spark plug
hole. For replacement use Champion RJ-19LM only.
NOTE: A resistor spark plug must be used for
replacement.
3. Turn by hand until snug.
4. Use a wrench or socket to tighten up.
OPERATION
Please do not start your auger until you have read
the Engine Manual that came with your engine, and
the section in this manual titled Safety. If you have
read these, follow the steps below to start your auger.
Always perform pre-start checklist before starting the
engine.
1. Read engine manual and follow instructions for fuel
type, starting, etc.
2. The clutch will transfer maximum power after about two
hours of normal operation. During this break-in period
clutch slippage may occur. The clutch should be kept
free of oil or other moisture for efficient operation. Each
unit is tested at the factory, but is not operated for the
full break-in period.
3. Your auger should be operated no more than 20
degrees in any direction during continuous use and
limited to 30 degrees intermittently. Recommended for
adequate lubrication and fuel delivery.
It is recommended that the unit not be tilted at
more than a 30° angle from the upright position.
Failure to do so can cause fuel and/or oil leakage.
4. When digging in heavy soil, pump the unit with an up
and down motion in the hole for every one foot of depth.
5. Never run engine indoors. Exhaust fumes are deadly.
6. Do not use an earth auger in ice.
Page 4
OPERATION
CAUTION
CAUTION