EarthQuake E43 earth auger powerhead Manual do operador - Página 6

Procurar online ou descarregar pdf Manual do operador para Equipamento para relva e jardim EarthQuake E43 earth auger powerhead. EarthQuake E43 earth auger powerhead 16 páginas. Power earth auger
Também para EarthQuake E43 earth auger powerhead: Manual do operador (17 páginas)

Imprimir página

EarthQuake E43 earth auger powerhead Manual do operador

Mixing F

Mixing Fuel and Filling F

Mixing F

uel and Filling F

uel and Filling Fuel T

Mixing F

uel and Filling F

Avoid injury! Never store engine with fuel in the tank

indoors. Fuel and fuel vapors are highly flammable.

Avoid injury! Never mix fuel and oil directly in engine

fuel tank. Use only non-metal, portable fuel containers

approved by the Underwriter's Laboratory (U.L.) or

the American Society for Testing & Materials (ASTM).

Avoid injury! An adult must always handle and fill

the engine with fuel.

Mixing Fuel

1. Fuel must be mixed in a container outside in a well

ventilated area.

2. Fill certified fuel container 1/4 full of recommended fuel.

3. Add recommended amount of 2-cycle oil.

4. Screw container cap on straight and tight.

5. Shake the container to mix fuel and oil.

6. Unscrew cap slowly to vent. Add the remainder of fuel

requirements.

7. Wipe away any spilled fuel or oil and allow to

evaporate before moving or transporting.

Avoid injury! Always handle gas in a well ventilated

area, outdoors, away from flames or sparks.

This engine uses a gas/oil mixture. DO NOT run on

straight gas only, engine damage will result.

1-800-345-6007

OPERA

OPERATION

OPERA

TION

OPERA

TION

uel T

uel Tank

uel T

ank

uel T

ank

CAUTION

Filling Fuel Tank

1. Shut-off engine and allow engine to completely cool

before refilling the fuel tank.

2. Move to a well ventilated area, outdoors, away from

flames and sparks.

3. Clean debris from area around the fuel cap.

4. Loosen fuel cap slowly. Place the cap on a clean, dry

surface.

5. Carefully add fuel without spilling.

6. Do not fill gas tank completely full, allow space for fuel

to expand.

7. Immediately replace fuel cap and tighten. Wipe off

spilled fuel and allow to dry before starting engine.

Avoid injury! DO NOT start engine if fuel is spilled.

Wipe off excess fuel and allow to dry. Remove engine

from area to avoid sparks.

Assembly

To attach the throttle control trigger assembly (#4809) to the

handlebar, screw the provided 10-24 x 1-1/4" phillips head

bolt through the handlebar and into the trigger assembly.

There is a 10-24 square nut fastened inside the trigger

housing. Screw the bolt into the square nut and tighten

securely. DO NOT OVERTIGTEN!

To attach auger to powerhead, align hole in at top of shaft

with output shaft hole. Insert bolt and secure bolt with

provided nut or allen wrench depending on size of auger.

NOTE: The ends of the bolt should be flush with auger

collar. Bolt head and thread end should never go

beyond earth collar.

Page 6

CAUTION