EarthWay 2600A-Plus Estate Manual de instruções de montagem e funcionamento - Página 2
Procurar online ou descarregar pdf Manual de instruções de montagem e funcionamento para Espalhador EarthWay 2600A-Plus Estate. EarthWay 2600A-Plus Estate 8 páginas. Broadcast spreader
Também para EarthWay 2600A-Plus Estate: Instruções de montagem e de utilização (5 páginas)
Imprimir página
4. Install lower handles onto Frame and secure with ¼-20 x 2¼"
bolt through hole in Frame Braces and through the hole in frame
install locknut.
Next, Slide the axle (Coast Wheel side first) through
the right side lower handle and into the gearbox (with the arrow
facing the FRONT), you will need to rotate the axle to engage
with the gearbox, then through the left side lower handle.
Axle Bearing
Flat
Side
NOW GO BACK AND TIGHTEN ALL NUTS
AND BOLTS, DO NOT OVER TIGHTEN.
6. Install drive wheel to axle using pin hole nearest to lower
handles as shown. Insert 1¾" Cotter pin through wheel and
through axle. Bend with pliers to prevent pin from falling out.
7. Install coast wheel to axle using outside pin hole. As shown, add the flat washer, and insert ¾" Cotter pin through axle (not
thru the wheel). Bend with pliers to prevent pin from falling out.
8. Install Handle Shaft as shown below using (2) 1/4-
20 x 1½" Hex Bolt and (2) 1/4-20 Locknuts
1/4 - 20 Lock-nut
1/4 - 20 x 1-1/2" Bolt
PAGE 2
Notch
5. Install the bearings over the axle
and press into the notches of the
lower handle as shown above.
1/8" X 1-3/4" Cotter Pin
DRIVE WHEEL
TURN SPREADER UPRIGHT ON TO WHEELS.
Handle Shaft
Slide Axle through as shown
Right
Side
1/4-20 x 2-1/4"
Bolt
33107
Slide wheels on axle as shown
Right
Side
~~~IMPORTANT~~~
9. Insert (2) 1/4-20 x 1½" Hex Bolt through Gauge and Linkage
Assembly, then through the Upper Handle, Handle Shaft, Upper
Handle and secure with (2) 1/4-20 Locknuts as shown at the right.
Drive
1/8" X 3/4" Cotter Pin
Left
Side
COAST WHEEL
Upper Handle
1/4 - 20 Lock-nut
1/4 - 20 x 1-1/2" Bolt
Left
Side
1/4-20 x 2-1/4"
Bolt
Coast
33106
34103
1" OD. Washer