EarthWay C24HDS-NC Manual de instruções de montagem e funcionamento - Página 2
Procurar online ou descarregar pdf Manual de instruções de montagem e funcionamento para Espalhador EarthWay C24HDS-NC. EarthWay C24HDS-NC 6 páginas. Broadcast spreader
Imprimir páginaImpeller
Cross Brace
Gearbox Brace
COAST WHEEL
HOLE
Gearbox & Axle Assembly
3. Install impeller onto pinion shaft. Insert 1/8" x 1-1/4" cotter pin
through impeller then through pinion shaft. Use hole nearest gear box.
Spread cotter pin to prevent from falling out. Next, install the Cross
Brace through the Gearbox Brace Support as shown above.
Lower Handle
Frame Brace
Cross Brace
5. Install Lower Handles onto Axle to both sides as
shown above.
6. A. Now insert 2-1/4" bolt with a cupped washer
through second hole in lower handle and through first
hole in frame, secure with cupped washer and locknut.
B. Now insert 1-1/2" bolt with a cupped washer through
first hole in lower handle, then through frame brace, and
finally into the threaded connector in the Cross Brace.
[NOTE: Dimples on frame braces must be facing toward
gearbox as shown.] DO NOT TIGHTEN YET.
C. Next insert 1-1/2" bolt through other end of frame
brace and through second hole in frame install cupped
washer and locknut.
DO NOT TIGHTEN YET.
PAGE 2
Pinion
Shaft
1/8 x 1-1/4"
Cotter Pin (#36105)
DRIVE WHEEL
HOLE
Coast wheel side
Gearbox
Axles Assembly
1/4-20 x 1-1/2"
Hex Head Bolt
and cupped washer
Step 6B
Step 6C
1/4-20 x 2-1/4"
Hex Head Bolt
and
cupped washer
Step 6A
tip: p
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS
STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
4. Install Gearbox by inserting the pinion shaft into hole in center
of hoppers bottom. The word "FRONT" on the gearbox must point
to FRONT of the hopper.
Gearbox & Axle Assembly
Impeller
Frame brace
1/4-20 Locknut
and cupped washer
N
otICe CUppeD waSHer LoCatIoNS
osition cuppeD washers between nut or bolt heaD anD chassis
Drive wheel side
Dimples
Cross Brace
1/4-20 x 1-1/2"
Pan Head Bolt
Lower Handle
Shut-Off
Pivot Rod
Frame