EarthWise NVPS42110 Manual do operador - Página 3
Procurar online ou descarregar pdf Manual do operador para Motosserra EarthWise NVPS42110. EarthWise NVPS42110 14 páginas. 18 volt, cordless convertible 2 in 1 pole saw / chain saw
Imprimir páginaUNPACKING
This product requires assembly.
Carefully remove the product and any accessories from the
box. Make sure that all items listed in the packing list are
included.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packaging material until you have carefully
inspected and satisfactorily operated the product.
PACKING LIST
Chain saw
Bar and Chain
Telescoping pole
Instruction manual
Blade cover
Battery pack and charger
Combination wrench/screwdriver
WARNING: If any parts are damaged or missing, do not
operate this product until the parts are replaced, Failure to
heed this warning could result in serious personal injury. Call
1-800-313-5111 for assistance.
Pole Assembly:
Remove rubber caps from the upper and lower pole sections.
Hold the two sections of the pole as shown with the arrows
facing up.
Insert the upper pole section until you hear the
sections click together. Make sure the two sections are se-
curely assembled by stretching the pole out and drawing it
back several times.
CONVERTING FROM CHAIN SAW TO POLE SAW
Pull the release latch located on the handle assembly
backwards in the direction of the handle. (see Fig 1) Slide
the handle downwards. (Fig 2)
Connect the handle to the rear of the telescopic pole and
the cutting head to the front end of the pole.
Make sure the release latch snaps in to lock the parts
securely.
ASSEMBLY
CONVERTING FROM POLE SAW TO CHAIN SAW
The electric chainsaw is a separate operating unit when not
assembled to the telescopic pole.
Disconnect handle and cutting head from ends of telescopic
pole as per the instructions provided.
Connect the handle directly to the cutting head by aligning the
grooves and pulling upward. The release latch must snap in
firmly and securely, locking the parts together.
ADJUSTING LENGTH OF TELESCOPIC POLE
To adjust the length of the telescopic pole, first remove the
battery pack from the saw. Rotate the collar counterclockwise
to loosen. Push poles toward each other to shorten the pole or
pull away from each other to lengthen the pole.
NOTE: Only extend the pole to minimum length required to
reach the limb to be cut.
Lock the pole in position by turning the collar clockwise until
firmly hand tight. Do not use wrench or pliers to over tighten
the collar. Damage to collar and/or pole may result.
WARNING: Failure to lock telescopic pole collars as directed
could result in personal injury,
WARNING: Do Not attempt to use the pole saw at a length
which does not allow you to maintain proper footing and
balance at all times.
3