Miele PW 6137 Manual de Instruções - Página 36

Procurar online ou descarregar pdf Manual de Instruções para Máquina de lavar roupa Miele PW 6137. Miele PW 6137 40 páginas.
Também para Miele PW 6137: Manual (48 páginas)

Imprimir página

Installation and connection

Water drainage

Drainage AV DN 70 on the machine side, DN 70

socket on-site. Transient flow rate 200 l/min.

Foam compensator SK

Increased foaming can lead to foam being

discharged from the vapour vent. A drain with siphon

(commercial off-the-shelf pipe material) can be

retro-fitted to dispose of the foam.

Installation examples

Electrical connection

The electrical connection must only be carried out by

a suitably qualified electrician in accordance with

local and national safety regulations (BS 7671 in the

UK).

The electrical components of machine PW 6xx7

comply with EN 60335-1 and EN 60335-2-7.

Open the machine cover. The connection points are

located on the carrier plate.

The machine is supplied ex-works for 3N AC 50-60

Hz. See data plate for details.

It is also available in the following versions:

3 N AC 380-415 V 50-60 Hz

3 AC 220-240 V 50-60 Hz

Connection should be made via a suitable isolator

which complies with local and national safety

regulations and which is easily accesible for

disconnecting the machine from the electricity

supply. Provision must be made on site to switch off

all poles. Switches with a minimum all-pole contact

gap greater than 3 mm are suitable for isolating the

machine. These include circuit breakers, fuses and

relays (IEC/EN 60947).

The isolator switch should be easily accessible for

servicing work.

If the machine is disconnected from the electricity

supply ensure adequate measures are taken to

ensure that it cannot be reconnected to the electricity

supply until all work has been carried out.

Please observe the wiring diagram supplied.

Equipotential bonding

Equipotential bonding must be carried out if required.

The electric heating is set ex-works to

9 kW

PW 6107

15 kW

PW 6137, PW 6167

18 kW

PW 6207.

The heating will only be activated with a minimum

suds levels of 50 mm column of water.

The motor is protected by a winding to prevent it

overheating.

Connection should be made in accordance with the

wiring diagram and installation diagram to a suitable

isolator, with an on-off switch which is easily

accessible for servicing. The wiring and installation

diagrams are important for the correct electrical

functioning of the machine.