Miele DA 239 Manual de Instruções - Página 19

Procurar online ou descarregar pdf Manual de Instruções para Campânula de ventilação Miele DA 239. Miele DA 239 32 páginas.

Imprimir página

Electrical connection and Technical data

Electrical connection

General notes

All electrical work should only be under-

taken by a suitably competent person

in strict accordance with national and

local safety regulations.

For extra safety it is advisable to install

a residual current device (RCD) with a

trip current of 30 mA.

The Technical data table (next page)

gives details for each appliance.

The data plate gives the necessary

data for connection. This is visible

when the grease filter has been

removed.

Check that these data correspond with

the voltage and frequency of the on-

site electricity supply.

Only for U.K.: Connection should be

made either by a double pole fused

spur connection unit or a fused plug

and switched socket. The On-Off

switch should be easily accessible

after the appliance has been built in.

Electrical connection U.K., AUS, NZ

The cooker hood is supplied for con-

nection to an a.c. single phase 230 -

240 V, 50 Hz supply.

Electrical connection and Technical data

Important

The wires in the mains lead are col-

oured in accordance with the following

code:

Green/yellow

Blue

= neutral

Brown

= live.

If the appliance is to be connected via

a plug and socket, please note the fol-

lowing:

As the colours of the wires in the mains

lead of this appliance may not corre-

spond with the coloured markings ident-

ifying the terminals in your plug, pro-

ceed as follows:

The wire which is coloured green and

yellow must be connected to the termi-

nal in the plug which is marked with the

letter E or by the earth symbol z or col-

oured green or green and yellow.

The wire which is coloured blue must

be connected to the terminal which is

marked with the letter N or coloured

black.

For U.K.: The wire which is coloured

brown must be connected to the termi-

nal which is marked with the letter L or

coloured red.

For Australia / New Zealand: The wire

which is coloured brown must be con-

nected to the terminal which is marked

with the letter A or coloured red.

WARNING:

THIS APPLIANCE MUST BE

EARTHED

= earth