Miele DA 5321 W Instruções de utilização e de instalação - Página 29

Procurar online ou descarregar pdf Instruções de utilização e de instalação para Campânula de ventilação Miele DA 5321 W. Miele DA 5321 W 36 páginas. Miele ventilation system operating and installation instructions
Também para Miele DA 5321 W: Dimensões do produto (2 páginas), Manual de operação e instalação (40 páginas), Instruções de utilização e de instalação (36 páginas)

The majority of the weight of the

installed ventilation system will be

supported by the lower retaining

plate. It must be firmly attached to

the stud framing behind the drywall.

If studs are not available in the

required locations, a plywood

backing (min. ½" (13 mm) thick)

spanning at least two studs must be

installed. Failure to adequately

support the weight as stated may

result in the ventilation system falling

off the wall, causing personal injury

and property damage.

(If plywood backing is not needed,

proceed to the included installation

sheet.)

To install a plywood backing

^ Determine and mark the location of

the retaining plate for the canopy as

outlined on the installation sheet.

^ Make a cutting line 3" (76 mm) above

and 3" (76 mm) below the outline of

the retaining plate.

Plywood backing

^ Find the studs to the left and right of

the mounting location by tapping the

wall or using a stud finder.

^ Mark a vertical cutting line along the

center of each stud.

Be careful not to damage any wiring

or plumbing that may be located

behind the wall. Make sure that the

power supply to the area where this

installation is being performed has

been turned off at the breaker panel

before cutting into the wall.

^ Remove the drywall between the

cutting lines and replace it with

plywood of a matching thickness

(min. ½" (13 mm) thick). Tape the

joints and refinish the wall.

^ Proceed to the included installation

sheet to complete the installation.