ALLNIC AUDIO H-1200 Manual do Proprietário - Página 6
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador ALLNIC AUDIO H-1200. ALLNIC AUDIO H-1200 8 páginas. Phono stage
Imprimir página
transformer in the H-1200 can accept cartridges with up
to 300 ohms internal impedance.
INITIAL POWER-ON
PLEASE NOTE – CAUTION!
Be sure you have turned the volume down or otherwise
muted your preamplifier before turning on the H-1200.
Also, make sure all your connections are snug.
1) Once you have your H-1200 in place, all
connections have been made to your turntable
and preamplifier, the MC (for moving coil, top
position) / MM (for MM, bottom position) switch
on the face H-1200 to the appropriate position
(Please refer to Figure 2).
2) Move the switch marked with the vertical line
above it and the circle below it (this is the power
switch to the "on" position – that means the
switch is pushed up toward the vertical line. Of
course, the off position is the reverse, moving the
switch down toward the circle below it.
OPERATION
When the Allnic Audio H-1200 has powered up, the light
above the word "ALLNIC" will illuminate.
The Allnic Audio H-1200 is now ready for operation.
To avoid surges to the speakers, it is best to change from
MM or MC input to the other only with your preamplifier
volume down or otherwise muted.
From this point on, operation is straight-forward. Of
course, always BE CAREFUL about differences in gain
between your sources. Generally, disc players and tuners
will have greater gain than phono stages. That means the
volume setting for listening to your turntable might be
too high for listening to CD's.
When you are finished listening, turn off your power
amplifier(s); then turn off your preamplifier and then the
H-1200 last.
In the case of any failure, please contact Hammertone
Audio for assistance.
TUBES
The H-1200 uses the following tubes:
Two (2) x 6112
Two (2) x 6021
All consequences of changing or attempting to change
tubes are borne by the user unless by express agreement
between the owner and Hammertone Audio. Allnic Audio
and Hammertone Audio are not liable in any way
whatsoever for any injury or loss incurred by the user or
for damage to the H-1200, any of its parts, or tubes or
replacement tubes resulting from the user changing or
attempting to change tubes.
SPECIFICATIONS
FOR THE ALLNIC AUDIO H-1200 PHONO STAGE
Inputs:
Ground:
Outputs:
Frequency (R.I.A.A):
Voltage Gain:
Input Impedance:
Maximum Input
Voltage
(MM, non-clipping):
THD
(Total Harmonic
Distortion):
Output Impedance:
6
MC (Moving Coil – unbalanced
(RCA) × 1 pair
MM (Moving Magnet -
unbalanced (RCA) × 1 pair
Screw Type x 1
Unbalanced (RCA) × 1 pair
20Hz - 20KHz (±0.3db)
+70db (1 KHz) MC
+38db (1 KHz) MM
MC - up to 30Ω (See
"Impedance", above)
MM 47kΩ
20Hz / 30mV
100Hz / 60mV
1KHz / 300mV
10KHz / 500mV
Less than 0.3%
(1 KHz, Output 1V)
1.2kΩ (On - off method)