DIAKAT RK-10 Manual do operador - Página 9

Procurar online ou descarregar pdf Manual do operador para Serra DIAKAT RK-10. DIAKAT RK-10 9 páginas. Roofing saw

RK10

RK10S S S S

RK10

Roofing saw

4.3. Termination of work

1. Stop the engine and shut off the fuel, implement all steps described in the engine

manual.

2. Clean the machine including the inside of the tool cover and check the wear of the tool.

3. Store the chaser in safe and dry place.

The basic steps of preventive maintenance described in this manual can be carried out by

the operator appointed by the entrepreneur. We recommend that all repairs and

adjustments beyond the scope of this manual are carried out by authorised service centre.

!ATTENTION! In the guarantee period it is prohibited to interfere with the engine and

power transmitting components in any manner whatsoever!

!ATTENTION ! It is prohibited to change the rev setting in any way!

Regular cleaning prolong the life of the machine its components and tools. After finishing

work clean the machine from dust and dirt by wet cloth or air before storing. Never use

pressurised water for cleaning.

Check the tightness of screw joints before every start of the machine. Regularly check the

tightness of tool fastening nut.

See engine manual.

Take extra care about cleanness of the engine and its cooling fins. Dirty engine=short life.

Clean the air filter regularly even during single shift if necessary. If the chaser is not used

in two month, change the oil.

Regularly check the wear and soiling of tools. If the TC tips are almost worn off, change

the tool.

Regularly check the tautness of the V belts. The deflection of the V belt under the

pressure of an index finger should be approximately 20 mm.

If the v belts needed to be drawn tauter proceed as follows:

Always carry this operation with cold, switched off engine.

1. Loosen the four bolts by which the engine is mounted on the undercarriage.

2. Push the engine backwards.

(You can check the tautness of the belts trough the hole in the V belt cover.), Retighten

the bolts

Page 8 of 8