ALLNIC AUDIO D-3000 Manual do Proprietário - Página 4
Procurar online ou descarregar pdf Manual do Proprietário para Conversor de multimédia ALLNIC AUDIO D-3000. ALLNIC AUDIO D-3000 11 páginas. Digital to analog converter
Imprimir páginaUse only a soft, lint-free cloth dampened slightly with water only (NO cleaning fluids!) to clean the
faceplate and chassis of the D-3000 DAC.
B.
Connectors
You may use any good quality contact cleaner recommended for such applications to clean the
contacts from time to time, as you deem appropriate.
INITIAL SET-UP
A. LOCATION, LOCATION, LOCATION
Like all audio products using tubes, the Allnic Audio D-3000 needs to be placed on a solid base that is
not subject to vibration or sudden shock, and that provides good air circulation around, above and
below the unit.
DO NOT cover the top of the D-3000 tube chimneys.
•
DO NOT drop the unit! For those who may want to place the D-3000 on some kind of
•
aftermarket isolation feet or similar devices, dropping one side of D-3000, or the whole unit
may result in damage to the unit or tubes that will not be covered by warranty.
DO NOT place the unit near a strong light or heat.
•
DO NOT place anything heavy on the unit.
•
DO NOT allow rubber or vinyl materials to rest on the unit's chassis for long periods of time.
•
This could discolour the metal.
DO place the unit on a shelf or stand that is stable and not subject to vibration or sudden shock.
•
DO consider using a high quality power cord, as well as inter-connects for both inputs and
•
outputs. The D-3000 is a highly sensitive piece of electronic designed for neutrality and will
output what you put into it.
DO try to place the D-3000 well away from major sources of RFI and EMI; though well shielded,
•
the D-3000 will function best away from large power transformers and other sources of such
interference.
B. POWER CONNECTION
The D-3000 DAC uses a standard three prong male IEC connection for AC input on the right hand
of the rear of the unit's chassis. You need a power cord with a female three prong IEC connector
at one end.
The D-3000 will be set internally for your location's electrical system characteristics. Please check
the setting for electrical input on the label on the rear of the unit to confirm that your D-3000
matches your location's electrical system. For North American customers, the D-3000 is set
internally for AC 110/220 volt – 60 HZ operation. There is no way to change this to another AC
setting without return of the unit to the factory for re-wiring, at the owner's cost, including
transport both directions.