DIAL ENGINEERING IUPITER Series Manual de instruções de utilização - Página 7
Procurar online ou descarregar pdf Manual de instruções de utilização para Carregador de bateria DIAL ENGINEERING IUPITER Series. DIAL ENGINEERING IUPITER Series 17 páginas. 24 v/10 a
Também para DIAL ENGINEERING IUPITER Series: Manual de instruções de utilização (13 páginas)
Imprimir página
Troubleshooting
Three types of errors can be distinguished:
1. Errors before the charging process has been started
The charging process cannot be started due to an error. Please separate the
charger from the supply network and check the following points:
– Is the battery connected with a good contact to terminals and has
the correct polarity been ensured?
– Are the battery cables and all plugs firmly secured?
– Are there any defects at the battery or the cables?
Please reconnect the charger to the mains supply network after correction of
the above-mentioned points. In the case of another error (LED RED flashes),
please contact the customer service!
EN
2. Errors during charging process
The charging process has been canceled. There are many reasons for this.
Please separate the charger from the supply network and check the following
points:
– Has the charger been constantly connected to the supply network?
– Has the mains cable been inserted with a good contact to terminals?
– Are the battery cables and all plugs firmly secured?
– Has a permitted battery been connected?
– Are there any defects at the battery or the cables?
Please reconnect the charger to the mains supply network after correction of
the above-mentioned points. In the case of another error (LED RED illumina-
tes), please contact the customer service!
3. Critical errors
Disconnect the device from the mains, wait for at least 5 minutes and
reconnect to the mains. If the error remains please contact the customer
service.
EN