Dialogic IMG 1010 Manual de início rápido - Página 7

Procurar online ou descarregar pdf Manual de início rápido para Porta de entrada Dialogic IMG 1010. Dialogic IMG 1010 10 páginas. Connecting dc power
Também para Dialogic IMG 1010: Manual de instruções de instalação (6 páginas), Manual de início rápido (11 páginas), Manual de início rápido (18 páginas), Manual de início rápido (10 páginas), Manual de instruções de instalação (9 páginas), Manual de início rápido (4 páginas)

Connecting and Configuring Network Management Port 'CTRL 0'

The information below will provide the user with a basic setup sequence for connecting

and configuring the IMG 1010 along with the GCEMS server to download system software

and start configuring the IMG 1010 using the ClientView GUI. On the rear of the IMG 1010

are the network interfaces. The first interface -CTRL 0- is a Fast Ethernet port dedicated

to network management. This port is connected to the GCEMS server and allows the

GCEMS server to access the IMG 1010.

1. Connect up the cables as shown in the first figure below.

2. Once the cables are connected, configure FTP and DHCP on the GCEMS server. Locate

the MAC address that is printed on a label located on the underside rear of the IMG

1010. This will be used in the dhcpd.conf file creation.

For more information on how to set up the services refer to the topics under the following

sections in the Online Documentation

IMG 1010-Installation and Setup Guide > IMG 1010-Software Installation and Setup

•

If your setup requires using an SD card to load system software refer to the topics under

the IMG 1010-SD Card heading below in Online Documentation.

IMG 1010-Installation and Setup Guide > IMG 1010-SD Card

•

Dialogic Corporation

IMG 1010 Quick Start Guide

Part # 07-8728-04

Page 7 of 9