Dialogic Integrated Media Gateways IMG 1010 Manual de instruções de instalação - Página 4

Procurar online ou descarregar pdf Manual de instruções de instalação para Porta de entrada Dialogic Integrated Media Gateways IMG 1010. Dialogic Integrated Media Gateways IMG 1010 6 páginas. Integrated media gateway release 10.3.x / 10.5.x

Imprimir página

Dialogic Integrated Media Gateways IMG 1010 Manual de instruções de instalação

Installing a Dialogic

IMG 1010 Integrated Media Gateway.

Caution:

Electrostatic Discharge Protection (EDP) must always be used. Electrostatic Discharge (ESD)

protective straps, shoes, or mats must be used when working with electronic components.

Electrostatic discharge from your body can damage integrated circuits during installation.

Required Tools and Parts:

Dialogic

IMG 1010 VoIP Module or Dialogic

4 Phillips pan head screws (Dialogic supplied).

#1 Phillips head screwdriver (customer supplied).

Remove Dialogic

1. Switch power to OFF (O) at rear of docking station.

2. Loosen the two ejector captive fasteners located on each side of the front panel.

3. Lift the ejectors upward and pull to unseat the tray from the docking station.

4. Remove Dialogic

IMG 1010 Motherboard. See

Motherboard

Tray.

5. Locate Module on Dialogic

and Media Module Positions.

Installing Dialogic

Position the module over the four standoffs on Dialogic

Align the connectors on the module with the connectors on the motherboard and press together.

See diagram below:

Cautions:

The connectors must be properly aligned and fully seated.

When pressing the module onto the motherboard do not press on the components installed on the

module; instead, do press on an open area on the edge of the Printed Circuit Board itself.

Attach the module with the four (4) Phillips pan head screws. Do not over tighten the screws.

(Recommended torque: 3-5 in-lbs (.34-.56 N-M)).

Dialogic Corporation

Installing a Dialogic

IMG 1010 VoIP or Media Module to Dialogic

IMG 1010 Motherboard

IMG 1010 Motherboard. See

IMG 1010 VoIP or Dialogic

Part # 07-8740-01

1010 VoIP or Media Module

IMG 1010 Media Module (Dialogic supplied).

Diagram 1 - Removing Dialogic

Diagram 2 - Dialogic

IMG 1010 Media Module

IMG 1010 Motherboard.

IMG 1010

IMG 1010 VoIP

Page 4 of 6