Dialogic Brooktrout TR1034 BRI Manual de instalação - Página 2

Procurar online ou descarregar pdf Manual de instalação para Placa PCI Dialogic Brooktrout TR1034 BRI. Dialogic Brooktrout TR1034 BRI 2 páginas. Pci fax board
Também para Dialogic Brooktrout TR1034 BRI: Manual de instalação (2 páginas)

Imprimir página

Before using your BRI service, you must configure

certain parameters. See your software documentation

for details.

See Figure 4 for pinout details for your board:

Port A

Port B

No connection

TX Tip 0

TX Tip 1

RX Tip 0

RX Tip 1

RX Ring 0

RX Ring 1

TX Ring 0

TX Ring 1

No connection

Figure 4. Connector Pinouts

Understanding LED Signals

LEDs on the Mounting Bracket

The LEDs on the mounting bracket provide

information about the status of the different systems

on the board. To identify and locate these LEDs, see

Figure 5.

The following tables describe how the end panel

LEDs provide information:

BRI Status LED

BRI LED

Meaning

Red

Layer 1 is down. This can occur if the

cable is wired incorrectly or the CPE

or CO emulation is wrong.

Yellow

Layer 1 is up, but layer 2 is down.

This state can occur if the protocol

has not been initialized, the D

channel has not been enabled, or the

clocks have not synchronized.

Green

Layer 1 is up, and layer 2 is up.

Red/green

The board is currently receiving CRC

errors.

Channel LEDs

Meaning

Off

Channel is idle.

Flashing green

Channel is being set up or is

connected.

Board Status LED

Meaning

Flashing yellow

Board is powered up and is

passing self test checks.

Steady red

Board is powered up, and the self

test has failed.

Flashing yellow

Board is powered up and is

and green

downloading firmware.

Flashing green

Firmware is downloaded, and the

board is in service.

Solid green

Board is hung, needs to be reset.

Flickering red

Board has failed, needs to be reset.

Off

Board has no power, or board is

hung and needs to be reset.

Port A ISDN

Module Number Switch (SW-1)

Termination Jumpers

Port A

RJ-45 Connector

Port B

RJ-45 Connector

BRI Status LEDs

Channel LEDs

Board Status LED

Port B ISDN

Mounting Bracket

Termination Jumpers

This graphic displays a Dual BRI board.

Figure 5. Dialogic® Brooktrout® TR1034 BRI PCI

Series Fax Board

LEDs on the Dialogic® Brooktrout® Fax

Board

The LEDs on the board provide information about the

status of the board. To locate these LEDs, see

Figure 5.

The following table describes how the LEDs on the

board provide information:

LED

Meaning

DSP

Displays the status for the DSP. After the

firmware is loaded and during normal

execution, this LED blinks about every

second. If the LED is not blinking, the DSP

firmware is not running.

Power

Steady green indicates good board power.

DSP LED - D7

PCI Connector

Power LED - D10

Using the Dialogic® Brooktrout®

TR1034 BRI Fax Board

Once you have installed the TR1034 BRI Fax Board, install

and configure your voice or fax software application

according to instructions included with the software.

Getting Help

Dialogic provides technical support for customers who have

purchased hardware or software products from Dialogic. If

you purchased products from a reseller, please contact that

reseller for technical support.

This equipment contains no user serviceable parts and is not

intended for repair by unauthorized personnel.

If you experience problems with the TR1034 BRI Fax

Board, for repair or warranty information, please use the

web site below. If the equipment is causing harm to the

telephone network, the telephone company might request

that you disconnect the equipment until the problem is

resolved.

www.dialogic.com/support

reproduce this document in whole or in part without permission in writing from Dialogic

Corporation at the address provided below.

All contents of this document are subject to change without notice and do not represent a

commitment on the part of Dialogic Corporation or its subsidiaries. Reasonable effort is

made to ensure the accuracy of the information contained in the document. However, due

to ongoing product improvements and revisions, Dialogic Corporation and its subsidiaries

do not warrant the accuracy of this information and cannot accept responsibility for errors

or omissions that may be contained in this document.

INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH

DIALOGIC® PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED, BY ESTOPPEL OR

OTHERWISE, TO ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED BY THIS

DOCUMENT. EXCEPT AS EXPLICITLY SET FORTH BELOW OR AS PROVIDED IN A

SIGNED AGREEMENT BETWEEN YOU AND DIALOGIC, DIALOGIC ASSUMES NO

LIABILITY WHATSOEVER, AND DIALOGIC DISCLAIMS ANY EXPRESS OR IMPLIED

WARRANTY, RELATING TO SALE AND/OR USE OF DIALOGIC PRODUCTS

INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A

PARTICULAR PURPOSE, MERCHANTABILITY, OR INFRINGEMENT OF ANY

INTELLECTUAL PROPERTY RIGHT OF A THIRD PARTY.

Dialogic products are not intended for use in medical, life saving, life sustaining, critical

control or safety systems, or in nuclear facility applications.

It is possible that the use or implementation of any one of the concepts, applications, or

ideas described in this document, in marketing collateral produced by or on web pages

maintained by Dialogic Corporation or its subsidiaries may infringe one or more patents or

other intellectual property rights owned by third parties. Dialogic Corporation or its

subsidiaries do not provide any intellectual property licenses with the sale of Dialogic

products other than a license to use such product in accordance with intellectual property

owned or validly licensed by Dialogic Corporation or its subsidiaries. More detailed

information about such intellectual property is available from Dialogic Corporation's legal

department at 9800 Cavendish Blvd., 5th Floor, Montreal, Quebec, Canada H4M 2V9.

The software referred to in this document is provided under a Software License

Agreement. Refer to the Software License Agreement for complete details governing the

use of the software.

Dialogic Corporation encourages all users of its products to procure all necessary

intellectual property licenses required to implement any concepts or applications and does

not condone or encourage any intellectual property infringement and disclaims any

responsibility related thereto. These intellectual property licenses may differ from country

to country and it is the responsibility of those who develop the concepts or applications to

be aware of and comply with different national license requirements.

Dialogic, Dialogic Pro, Brooktrout, Cantata, SnowShore, Eicon, Eicon Networks,

Eiconcard, Diva, SIPcontrol, Diva ISDN, TruFax, Realblocs, Realcomm 100, NetAccess,

Instant ISDN, TRXStream, Exnet, Exnet Connect, EXS, ExchangePlus VSE, Switchkit,

N20, Powering The Service-Ready Network, Vantage, Connecting People to Information,

Connecting to Growth and Shiva, among others as well as related logos, are either

registered trademarks or trademarks of Dialogic.