ALLREDI MARCO 151E Manual do operador - Página 12

Procurar online ou descarregar pdf Manual do operador para Interruptor ALLREDI MARCO 151E. ALLREDI MARCO 151E 16 páginas. Remote control switch

Imprimir página

W-562

Always depressurize

the entire system,

disconnect all power

sources and lockout/

tagout all components

before any maintenance

or troubleshooting is

attempted. Failure to

comply with the above

warning could cause

electrical shock and

inadvertent activation of

equipment resulting in

death or serious injury.

W-520

The use of this product

for any purpose other

than originally intended

or altered from its

original design is

prohibited. Failure to

comply with the above

warning could result in

death or serious injury.

Marco

151E Remote Control Switch

MAINTENANCE

Disassemble and Assemble Marco

Maintenance of the Marco

the immediate replacement of damaged or worn parts.

Disassemble:

1) Remove Nut (7) from Shoulder Screw (9).

2) Slide Shoulder Screw (9) from Body (8).

3) Remove Washer (2), Handle (1), and Spring (14) from Body (8).

4) Remove Nut (10) from Shoulder Screw (13).

5) Remove Shoulder Screw (13) from Body (8).

6) Remove Washer (11), Spring (12), and Safety Tab (15) from Body (8).

7) Remove Screw (4) from Cord Grip (5).

8) Remove two Screws (3), and remove Micro Switch (6) from Body (8).

Assemble:

1) Place Micro Switch (6) on Body (8). Align holes in Micro Switch with Holes (B).

2) Install two Screws (3) in Holes (B).

3) Place Cord Grip (5) over power cord and align Cord Grip with Holes (C). Install two

Screws (4) in Holes (C).

4) With flat side of Safety Tab (15) facing away, place offset leg of Spring (12) against

Safety Tab and insert Shoulder Screw (13) in hole on right side of Safety Tab. Place

assembled components on Body (8) with straight leg of Spring at Location (A) on body.

Insert Shoulder Screw (13) through holes in Safety Tab (15) and Body (8).

5) Place Washers (11) and Nut (10) on Shoulder Screw (13) and tighten. Test movement

of Safety Tab (15) by pulling down. If binding occurs, loosen Nut and repeat test.

6) Partially insert Shoulder Screw (9) in Body (8). Place Spring (14) on Shoulder Screw

with straight leg of Spring (14) on the bottom facing Safety Tab (15).

7) Align Handle (1) with uprights and insert Shoulder Screw (9) through hole in Handle.

Place Washer (2) on Shoulder Screw.

8) Install Nut (7) on to Shoulder Screw (9) and tighten. Test movement of Handle (1) by

depressing Handle. If binding occurs, loosen Nut and repeat test.

151E Remote Control Switch

151E Remote Control Switch is limited to the daily cleaning and