Miller 907431002 Manual do Proprietário - Página 36

Procurar online ou descarregar pdf Manual do Proprietário para Sistema de soldadura Miller 907431002. Miller 907431002 44 páginas.

Imprimir página

7-6. Remote Process Select

OM-245171 Page 30
.
A complete Parts List is available at www.MillerWelds.com
50
25.0
PULS
50
25.0
Decimal point indicates wire
feeder right side is active.
PULS.
50
Decimal point indicates wire
feeder right side is active.
This power source can be used with wire
feeders that support Remote Process Se-
lect. This feature allows the operator to
switch the active welding process between
MIG and Pulsed MIG at the wire feeder. To
determine if the welding system is Remote
Process Select capable, connect the wire
feeder to the power source and review the
power source display variations shown be-
low.
.
Power Source Display − Wire Feeder with
Remote Process Select Not Detected
When the power source Right Display is
blank, a wire feeder with Remote Process
Select is not detected. Set the active weld
process at the power source.
Power Source Display − Wire Feeder with
MIG
Remote Process Select Detected
When the power source Right Display is
MIG, a wire feeder with Remote Process Se-
lect is detected and set for MIG operation.
The active weld process can only be
changed at the wire feeder.
Power Source Display − Wire Feeder with
Remote Process Select Detected and Set
for Pulsed MIG
When the power source Right Display is
PULS, a Remote Process Select wire feeder
is detected and is set for Pulsed MIG opera-
tion. The active weld process can only be
changed at the wire feeder.
Using a Dual Wire Feeder with Remote
Process Select
When using a dual wire feeder with Remote
Process Select, different weld programs for
the left and right side can be selected. The
power source MIG and Pulsed MIG pro-
grams for the left side of wire feeder are se-
lected with the left side of the wire feeder act-
ive. The power source MIG and Pulsed MIG
programs for the right side are selected with
the right side of the wire feeder active. When
the right side of the wire feeder is active, the
power source Right Display will show a
decimal point in the lower right hand corner
as shown.
Power Source Display − Dual Wire Feed-
MIG.
er with Right Side Active and Set for MIG
Power Source Display − Dual Wire Feed-
er with Right Side Active and Set for
Pulsed MIG
When used with an XMT power source,
the Process Select knob must be set to
Pulsed MIG for Remote Process Select
to be active.