Miller Axcess 300 Manual do Proprietário - Página 18
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de soldadura Miller Axcess 300. Miller Axcess 300 36 páginas. Arc welding power source and wire feeder with meters
Também para Miller Axcess 300: Manual do Proprietário (44 páginas), Manual do Proprietário (48 páginas)
Imprimir página
2-10. Inductance Selection
Tools Needed:
3/8, 7/16 in
3/8 in
Weld Bead Using The Tap Stabilizer
Connection With 17 Volts, 100 Amps
2-11. Electrical Service Guide
Input Voltage
Input Amperes At Rated Output
Max Recommended Standard Fuse Rating In Amperes
Min Input Conductor Size In AWG/Kcmil
Max Recommended Input Conductor Length In Feet (Meters)
Min Grounding Conductor Size In AWG/Kcmil
Reference: 1999 National Electrical Code (NEC)
1 Consult factory for circuit breaker applications.
2 "Time-Delay" fuses are UL class "RK5" .
3 "Normal Operating" (general purpose – no intentional delay) fuses are UL class "K5" (up to and including 60 amp), and UL class "H" ( 65 amp and
above).
OM-1317 Page 14
2
5
4
6
1
2
Time-Delay
Normal Operating 3
1
3
7
Weld Bead Using The End Stabilizer
Connection With 17 Volts, 100 Amps
Remove left side panel.
1
Stabilizer Z
Tapped stabilizer Z is factory con-
nected to the stabilizer tap which
suits most GMAW applications.
Stabilizer Z controls the inductance
applied to the weld current. To in-
crease inductance and wet out the
weld puddle, connect to stabilizer Z
ending.
To change inductance proceed as
follows:
2
Lead 24
3
Stabilizer Z Tap
4
Stabilizer Z Ending
5
Lead 25
To decrease inductance, connect
lead 25 to stabilizer tap and secure.
Reinstall side panel.
6
Typical Weld Bead Using The
Tap Stabilizer Connection
Use the tap Stabilizer connection
when welding with 100% CO
shielding gas.
Use either stabilizer connection,
depending upon your arc prefer-
ence, while welding with a mixed
shielding gas.
Use stabilizer Z ending to weld on
stainless steel.
7
Typical Weld Bead Using The
End High Stabilizer
Connection
Use the end Stabilizer connection
to reduce weld bead crowning, and
spread the weld puddle.
Install left side panel.
Ref. ST-148 265-B / Ref. ST-801 379-B
200
230
460
54
47
23.5
60
50
25
80
70
35
8
8
12
109
144
236
(33)
(44)
(72)
8
8
12
2