Miller Trailblazer 251 Manual do Proprietário - Página 17
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de soldadura Miller Trailblazer 251. Miller Trailblazer 251 48 páginas. Engine driven welding generator
Imprimir página
4-1. Installing Welding Generator
Movement
Y Do not lift unit from end.
OR
Location
OR
4-2. Engine Prestart Checks
SECTION 4 – INSTALLATION
Airflow Clearance
18 in
(460 mm)
18 in
(460 mm)
Grounding
1
OR
Electrically bond genera-
tor frame to vehicle frame
2
by metal-to-metal contact.
(13 mm)
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
3
4
GND/PE
install1 1/97 – Ref. ST-800 652 / Ref. ST-800 477-A / ST-158 936-A / S-0854
1/2 in
Full
Gasoline
Full
1
Generator Base
2
Metal Vehicle Frame
3
Equipment Grounding
Terminal
4
Grounding Cable
Use #10 AWG or larger insulated
copper wire.
Y If unit does not have GFCI re-
ceptacles,
use
protected extension cord.
2
Check all fluids daily. Engine must
be cold and on a level surface. Unit
is shipped with 10W30 engine oil.
Engine stops if oil pressure gets too
low.
.
Follow run-in procedure in
engine manual.
Ref. ST-151 983 / ST-801 532-B
OM-485 Page 13
GFCI-