Miller S-74 MPa Plus Manual do Proprietário - Página 34

Procurar online ou descarregar pdf Manual do Proprietário para Acessórios de soldadura Miller S-74 MPa Plus. Miller S-74 MPa Plus 48 páginas.

8-4.

Setting A Start Sequence In Non-Synergic Pulse Or MIG

To turn on a Start sequence, press the

START button. The START ON INDICATOR

will illuminate indicating Start is active.

To turn off the Start sequence, press the

START button. The START ON INDICATOR

will turn off indicating Start is inactive.

To enter the START MENU press and hold

the START button until the START MENU

INDICATOR illuminates.

Rotate the LEFT ADJUST Knob to select

different menu items shown in the LEFT

DISPLAY. Rotate the RIGHT ADJUST Knob

to change menu item values shown in the

RIGHT DISPLAY.

OM-273244 Page 24

OM-289404 Page 28

To exit the START MENU, press and re-

lease the START button.

Items that can be adjusted in this menu are:

Start Wire Feed Speed (WFS) - Sets the

wire feed speed used during the Start Time.

Range of this setting is from (70 to 780

IPM).

Start Arc Length (ARC. L) - Sets the arc

length during the Start Time. Range of this

setting is from (0.0 to 100.0) and the level is

set to match start WFS.

�

When MIG is selected in Setup Menu

Level 1 the start arc length setting will

be replaced by Start Voltage (VOLT).

Start Voltage (VOLT) - Sets the voltage dur-

ing the Start Time. Range of this setting is

dependent on the power source voltage

range or voltage range of the selected pulse

program.

Start Time (TIME) - The amount of time the

wire feed speed is active at the Start setting.

Range of this setting is from (0.1 to 0.5)

seconds.

Start Ramp Time (RAMP) - The amount of

time it takes to transition from the Start to

the weld wire feed speed setting. Range of

this setting is from (0.1 to 5.0) seconds.