Miller S-75SC Manual do Proprietário - Página 15

Procurar online ou descarregar pdf Manual do Proprietário para Acessórios de soldadura Miller S-75SC. Miller S-75SC 40 páginas.

Imprimir página

4-1. Specifications

Type of Input
Welding Power
Power
Source Type
24 Volts ac
Constant
Single-Phase
Voltage (CV)
10 Amperes
DC With 14-Pin,
50/60 Hertz
that Provides
Voltage and
Voltage and
Current
Feedback
NOTE

5-1. Site Selection

5
Wire feeder shown
is representative
only and does not
reflect actual unit.
SECTION 4 − INTRODUCTION
Welding
IP
Circuit
Rating
Dimensions
Rating
100 Volts,
IP 21
Length: 27 in
750 Amperes,
100% Duty
Width: 12-1/2 in
Cycle
Height: 14 in
Height: 14 in
If feeder is used with a welding power source that does not provide voltage and
current feedback through the 14-pin control cable, run-in will be disabled. Arc
voltage will not be displayed on feeders equipped with meters.
SECTION 5 − INSTALLATION
3
1
Overall
Maximum
Spool Weight
60 lb
(686 mm)
(27 kg)
(318 mm)
(356 mm)
4
2
6
Wire
Wire Feed
Diameter
Speed Range
Range
Standard
.023 to 5/64 in
Speed: 50 to
(0.6 to 2.0
1400 ipm (1.3
mm)
to 35.6 mpm)
Low Speed:
.023 to 1/8 in
20 to 400 ipm
(0.6 to 3.2
(0.5 to 10.1
mm)
mpm)
Y Do not put feeder where
welding wire hits cylinder.
Y Do not move or operate
equipment where it could tip.
1
Wire Feeder
2
Rubber Feet
Choose slot that allows all rubber
feet to sit securely on top of welding
power source.
3
Wire Spool/Reel
4
Gas Cylinder w/Hose And
Regulator (Customer
Supplied)
.
Shielding gas pressure not to
exceed 100 PSI (689 kPa).
5
Welding Power Source
6
Running Gear
OM-223 605 Page 11
Weight
43 lb
(19.5 kg)
48 lb
(21.7 kg)
802 806-A