Miller Compass XV2 Fluid Head Manual do operador - Página 4

Procurar online ou descarregar pdf Manual do operador para Acessórios para câmaras Miller Compass XV2 Fluid Head. Miller Compass XV2 Fluid Head 13 páginas.

Imprimir página

Operating Instructions

2. Mounting Your Camera

2.1 Remove the VERSA CAMERA PLATE by lifting the

SAFETY RELEASE LEVER on the PLATFORM (SLIDE LOCK

LEVER must be unwound (clockwise)) (Fig. 3a).

2.2 Attach the VERSA CAMERA PLATE to the camera

that the Centre of Gravity (C of G)

is approximately in the middle of the VERSA CAMERA

PLATE.

2.3 Tighten PAN/TILT LOCKS, mount the VERSA CAMERA

PLATE to the PLATFORM non-locking side first. The side

load lock mechanism will capture camera plate (distinct

click sound will be made when VERSA CAMERA PLATE is

retained). The VERSA CAMERA PLATE will be able to slide

freely (100mm) until SLIDE LOCK LEVER is tightened. (Fig.

3b).

2.4 Untighten TILT LOCK, slide the VERSA CAMERA PLATE

such that the camera's C of G is directly above the centre

axis of the Fluid Head, camera should be balanced (if

not slide camera backward or forward). Once balanced

tighten the SLIDE LOCK LEVER (anti-clockwise)

tighten TILT LOCK. (Fig. 3c).

If this cannot be achieved then reposition the VERSA

CAMERA PLATE on the Camera – step 2.2.

NOTES:

Refer to the camera's owners manual for correct method of

attachment to the VERSA CAMERA PLATE. Remove the 1⁄4"

screw or 3/8" screw as required.

The camera's C of G can be estimated by placing the

camera on to a round rod and then shifting it backwards

or forwards until a balance point – C of G - is achieved. It is

recommended to identify this point on the camera as it will

be useful in step 2.2.

Ensure SLIDE LOCK LEVER is tightened at all times when

you are not finding C of G or mounting/dismounting camera.

such

mark on the camera

and

C of G

Slide Lock Lever

Safety Release Lever

Fig. 3a

Slide 100mm

Versa Camera Plate

Fig. 3b

Centre Axis

Fig. 3c

Tilt Lock

Pan Lock