Miller AirArmor Manual do utilizador - Página 8
Procurar online ou descarregar pdf Manual do utilizador para Acessórios para motociclos Miller AirArmor. Miller AirArmor 22 páginas. Auto-darkening helmets helmet cooling system
Imprimir página
3-2. Installing Headgear And Shroud
Use bottom hole for
quick release Elite
and Titanium hel-
mets. Use top hole
for all other helmets.
OM-235 368 Page 6
3
5
1
1
2
3
4
5
Remove knobs, o−rings, and
washers
headgear. Remove headgear.
2
Use supplied towelette to clean
area inside helmet where Vel-
cro® will be installed. Allow
cleaned area to dry.
Remove backing from Velcro.
Install Velcro strip 5/8 in. (1.5
cm) from edge of quick release
Elite and Titanium helmets. For
all other helmets, install Velcro
3/4 in. (2 cm) from edge of hel-
met.
Position
4
headgear in helmet. Install
headgear mounting screw in
headgear bottom hole (quick re-
lease Elite and Titanium hel-
mets) or top hole (all other hel-
mets).
Secure headgear with knobs,
o−rings, and washers.
Align Velcro on shroud with Vel-
cro strip inside helmet. Press the
Velcro surfaces securely to-
gether.
Check for gaps between shroud
and helmet. Reposition shroud
and Velcro if necessary.
.
.
After installing shroud,
make sure there are no
gaps between shroud and
helmet edge.
Standard Headgear
Velcro Strip
Cooling System Headgear
Shroud
Velcro On Shroud
from
cooling
Remove shroud from hel-
met when using helmet with
the cooling system turned
off.
Ref. 231 425 / Ref. 804 111
standard
system