Miller Cool Belt Manual do utilizador - Página 18
Procurar online ou descarregar pdf Manual do utilizador para Acessórios para motociclos Miller Cool Belt. Miller Cool Belt 22 páginas. Auto-darkening helmets helmet cooling system
Imprimir página
3-12. Maintenance And Storage
Replace damaged or dirty filter. Do not wash filter, clean with compressed air, or reuse
dirty filter.
Never use solvents or abrasive cleaning solutions to clean the helmet cooling system .
Keep water and other fluids out of blower assembly.
Replace shroud after 50 washings. Shroud loses its fire retardant properties with re-
peated washing.
For best performance clean the equipment after each use. Use a soft cloth dampened with a mild soap
and water solution to wipe all external surfaces clean. Allow to air dry.
Product usage, workplace contamination levels, and other factors affect the life of the filter. Replace
filter if air flow is reduced due to a dirty filter (see Section 3-5).
Inspect connecting hose and replace if damaged or if inside of hose is extremely dirty.
If the helmet cooling system will not be used for an extended period, remove the filter and battery and
store them in a clean, dry, cool place free of solvent-based vapors.
3-13. Helmet Cooling System Troubleshooting
Trouble
Blower does not supply air
to shroud.
Blower cannot be turned
Off.
Blower runs for short time
even though battery is fully
charged.
Battery Level Indicator
light is On.
OM-235 368 Page 16
Verify This Statement
Press On/Off button.
Dead battery; recharge battery (see Section 3-4).
Verify battery is properly connected to blower body.
Remove blockage from blower outlet and hose.
Press and hold On/Off button for two to three seconds.
Be sure battery is properly connected to battery charger.
Replace filter.
Replace battery.
Replace charger.
Charge or replace the battery. The blower will operate for about 20
minutes after the light goes on. (The Battery Level indicator lights
for several seconds after blower is started.)
Remedy