Miller ICE-27T Manual do Proprietário - Página 27

Procurar online ou descarregar pdf Manual do Proprietário para Lanterna Miller ICE-27T. Miller ICE-27T 36 páginas. Air-cooled torches for plasma arc cutting
Também para Miller ICE-27T: Manual do Proprietário (36 páginas), Manual do Proprietário (38 páginas)

Miller ICE-27T Manual do Proprietário

6-7. Checking/Replacing Retaining Cup, Tip, And Electrode

Inspect shield cup, tip, and electrode for wear before cutting or whenever cutting speed has been significantly
reduced. Do not operate torch without a tip or electrode in place. Be sure to use genuine replacement parts.
A good practice is to replace both the tip and electrode at the same time.
Make sure this area is clean of
any debris.
Make sure swirl ring is clean of any
debris and no holes are obstructed.
2
Turn Off power source.
1
Shield Cup
Remove shield cup. Check cup for cracks,
and replace if necessary.
2
Tip
3
Opening
Overtightening will strip threads. Do not overtighten retaining cup
during assembly. Do not cross-thread parts causing stripping. Use
care during torch assembly and parts replacement.
Turn Off power source before checking torch parts.
3
New
Worn
Remove tip. Check tip, and replace if open-
ing is deformed or 50% oversize. If inside of
tip is not clean and bright, clean with steel
wool. Be sure to remove any pieces of steel
wool afterwards.
4
Electrode
Check electrode. If center has a pit more
than a 1/16 in (2 mm) deep, remove and re-
place electrode.
6
5
1
5
Swirl Ring
Remove swirl ring. Check ring, and replace
if side holes are plugged.
6
O-Ring
Check O-ring for cracks or worn spots, and
replace if necessary.
Carefully reassemble parts in reverse order.
4
New
1/16 in
(2 mm)
Pit
Worn
802 465
OM-225 216 Page 23