Aquaox C Series Manual de início rápido - Página 5

Procurar online ou descarregar pdf Manual de início rápido para Unidade de controlo Aquaox C Series. Aquaox C Series 8 páginas. Clack head

Fig 3 Filter diagram showing cut away of media

5. If possible at this point, fill tank completely with water. This will allow the softener resin to

settle and eliminate the need of "purging" the air out of the tank later.

6. Add a small amount of vegetable cooking oil to the tank threads and screw on the WS1 control

valve carefully. Alternatively you can use silicone grease, but do not use pipe joint compound,

Teflon tape, or Vaseline or other petroleum greases to lubricate tank threads.

7. See how the piping connects to the bypass valve. There are in and out arrows on the bypass

valve for the inlet and outlet pipe. Install inlet and outlet piping, drain tubing and brine line

tubing. The brine line tube is included and is shipped inside the brine tank.

8. Note that the over flow fitting on the side of the brine tank does not need to be connected,

unless the softener is installed in a closet or somewhere where overflowing salt water could

cause a problem. Water rarely overflows the brine tank however.

9. Add approximately 5 gallons of water to brine tank, then fill brine tank with salt, about 300 lbs,

or 6 50 lb bags. It is OK to use any kind of water softening salt; however we find that extra

coarse salt works better than the pellets. You do not have to add water to the brine tank again

after this first time during the start up.

10. Close the valve after the water softener. Connect a garden hose to the hose bib after the

softener and open hose bib. Turn on the water to the softener and allow the water to run out

the garden hose until the water is clear.

Clack WS1 Water Softener Installation Guide