AQUAPHOR RO-202S Manual de operação - Página 11
Procurar online ou descarregar pdf Manual de operação para Sistemas de filtragem de água AQUAPHOR RO-202S. AQUAPHOR RO-202S 16 páginas. Reverse osmosis system
Imprimir página
After replacing K1 and K2
filter cartridges of the water
treatment unit
• Open the inlet cock of the connecting assembly.
The flashing indicators of the K1 and / or K2
cartridges of the water treatment unit are
followed by a sound signal. The other indicators
are solid.
• Make sure the RO-202S connections are tight.
• КOn the front panel, flash the PUSH button
3 times to start the flushing mode of the water
pre-treatment unit. At this, 5 audible signals
sound, the indicator lights go out and the
flushing mode of the pre-treatment unit starts
and lasts 30 minutes.
• After flushing procedure is complete, your
RO-202S beeps 5 times and switches into
the operating mode automatically: filtration
and filling the tank with water, while the light
indicators of the pre-treatment unit flash (the
light signal is followed by a sound), the other
indicators are solid.
• Press and hold the PUSH button for at least
7 seconds to reset the cartridge life. The light
indication of the pre-treatment unit changes
from the flashing mode to the constant one,
and the audio signal stops.
After replacing
the membrane unit:
• Open the inlet cock of the connecting assembly.
The cartridge life light indicators turn on, the
flashing light indicator of the reverse osmosis
membrane unit is followed by a sound signal.
• Make sure the RO-202S connections are tight.
• Let the water through your RO-202S for 1 hour*.
• Close the treated water tap.
• Press and hold the PUSH button for at least
7 seconds to reset the cartridge life. The light
indication of the reverse osmosis membrane
unit changes from the flashing mode to the
constant one, and the audio signal stops.
ATTENTION! Do not disconnect your RO-202S
from the power supply when in the flushing
mode. Otherwise, the flushing process must
be repeated.
* The whole flushing procedure of the membrane cartridge takes no more than 24 hours and depends on its storage and trans-
portation conditions.
After replacing K7BM
filter cartridge of the water
conditioning unit
• Open the inlet cock of the connecting assembly.
The flashing indicators of the water conditioning
unit are followed by a sound signal. The other
indicators are solid.
• Make sure the RO-202S connections are tight.
• Close the treated water tap.
• When the storage tank is full (the light indication
turns off), open the tap for treated water and
wait when all the water has drained from the
storage tank (a weak water flow from the tap).
• Fill and empty the storage tank 2 more times.
• Press and hold the PUSH button for at least
7 seconds to reset the cartridge life of the
water conditioning unit. The light indication
of this unit changes from the flashing mode to
the constant one, and the sound signal stops.
8. Storage Tank
Maintenance
Empty the tank before use if you have not used
the system for more than 2 days.
Empty and refill the tank 3 times for flushing
before use if you have not used the system for
more than 2 weeks.
Then, you can use the system again.
ATTENTION! It is recommended to flush the
storage tank with a disinfectant solution at least
1-2 times a year.
9. Storage and
Transportation Rules
The RO-202S shelf life is 3 years before operation
when stored at + 5 to + 38 ºС, originally packed, in
closed and naturally ventilated rooms at a relative
humidity not exceeding 80%.
It is forbidden to turn the RO-202S system over,
to hit or to expose to other mechanical stresses.
11