Burley Launde 9304-C Instruções de instalação e manual do utilizador - Página 13
Procurar online ou descarregar pdf Instruções de instalação e manual do utilizador para Fogão a lenha Burley Launde 9304-C. Burley Launde 9304-C 20 páginas. Fireball with catalytic converters
Imprimir páginaOptional Convection Tube Cover Plate (91XX models only)
The cover plate is an option on the Fireballs for those people who do not like the appearance of
the convection tubes.
Fitting the cover plate is easy:
(1)
Offer the cover plate up to the stove and locate the clips on the rear into the tubes and push
it on.
(2.) Make sure it is fitted open at the top and flush at the bottom. This is important for the
convection heat to come through the tubes. Fitting the cover plate will not affect the efficiency
of the stove.
Additional inner glass screen – 9307 only
If your chimney has a good draw the Carlby will extract any smoke when refuelling, but when
connected to weaker flues or subject to downdrafts etc some smoke can spill when the door is
open. To prevent this, an additional inner glass screen is provided to lower the door aperture. The
installer should check the draw and fit the inner screen if required.
The screen is fitted as shown below (cut proof gloves should be worn in case of breakages).
1. With the door fully open, hold the glass horizontally inside the stove, holding the glass in the
middle near the bottom edge.
2. Tip the glass slightly forwards and move it upwards and forwards so the top edge is behind
the top of the door opening between the vertical square tubes.
3. Move the bottom of the glass forwards so it is vertical and then lower so the glass sits in the
notch at the front of the holding brackets.
4. Move the top of the glass backwards until it rests at an angle leaning backwards against the
top bar.
If fitted, the inner glass screen should be carefully cleaned at the same time as the door glass
before each firing of the stove.
Open at the top
Page 13 of 20