ChronoRemoteControl TR2 Manual

Procurar online ou descarregar pdf Manual para Controlo remoto ChronoRemoteControl TR2. ChronoRemoteControl TR2 2 páginas.

APRIMATIC TR2, TR4, TR2M and TR4M

To operate your new remote, you must code it:

A. Coding based on a remote control already in operation.

Position yourself near the radio receiver.

1) Simultaneously press all the buttons on the remote already in use until the

receiver emits a continuous beep.

2) Simultaneously press all the buttons on the new remote control. The acoustic

signal stops 1.5 sec, confirming the registration of the new remote control.

3) Release all buttons.

4) Press any key on the new remote. The buzzer should stop 1.5 sec and then

resume. The end of the beep (after about 30 seconds) signals the end of the

registration period.

5) Test your new remote control.

Note: If the buttons are not all pressed at the same time, the receiver does not

recognize the new remote.

Manual