Aquarea PAW-TG20C1E3STD Manual - Página 16

Procurar online ou descarregar pdf Manual para Caldeira Aquarea PAW-TG20C1E3STD. Aquarea PAW-TG20C1E3STD 19 páginas.

INSTALLATION OF SENSORS

On the upper side of the storage tank there are two sensor tubes for mounting the sensors for regulation of the system connection

of the hot water storage tank to other heating sources. The maximum diameter of the sensors is 8 mm.

Image 5: Installation of sensors

WARNING: Before any intervention into the interior of the storage tank disconnect it from the power supply! All

interventions must be carried out by qualified staff only!

WATER HEATER ASSEMBLY AND CONNECTION

Before connecting to power supply network, install a power supply cord in the storage tank, with a min. diameter of at least

1.5 mm

(H05VV-F 3G 1.5 mm

thermostat axis and unscrewing two screws.

An all-pole disconnect device must be installed in the electric installation to comply with the National Installation Regulations.

Image 6: Water heater assembly

Long sensor tube (lower tank position)

Short sensor tube (upper tank position)

). To do so, the protection cover must be removed. This is done by pulling out the knob on the