Aquarii RHEOS Manual de instalação - Página 6

Procurar online ou descarregar pdf Manual de instalação para Luz de inundação Aquarii RHEOS. Aquarii RHEOS 11 páginas. Slope recessed

MOUNTING OPTION

Slope Recessed (Mounting #8)

The parts of the Slope Recessed Mount are labeled as:

• A - Top Cover

• B - Junction Box Cover

• C - Junction Box

• D - Box Assembly

• E - Adjustment Bolts

• F - Extension Rails

• G - Communication Board

• H - Trim Ring

The fixture and mounting option are designed for non-IC (Insulation

Contact) Environments. Ensure insulation is kept away from the

fixture installation location.

Follow the steps below to secure the mount/fixture to the local site.

1. Loosen the four Bolts on the Left/Right Extension Rails and

extend them to the required mounting length, then tighten

the Bolts to secure the Rails in place.

2. Secure the Extension Rails to the sites building structure

using eight screws. See the table below for the

recommended screw parameters based on the present

building material.

WOOD

No. 12 x 2" Zinc-Plated Steel

Screws (3/16" pilot hole)

3. Loosen the Adjustment Nuts to adjust the orientation of the fixture inside the Box Assembly, then tighten the

Adjustment Nuts to secure the fixture in the desired orientation.

4. If a Trim Ring is required proceed to Step 5, if not, then Proceed to the Wiring Connections section of this manual.

5. Obtain the Trim Ring Springs from the separate packaging accompanying the fixture.

6. Secure the first end of the Trim Ring Springs to the Brackets

inside the Box Assembly.

7. Align the holes on Trim Ring so the Springs are completely

vertical.

8. Secure the Springs to the Trim Ring Holes and gently position

the ring against the sites ceiling surface.

9. See the image below for a Rheos installed in a Slope Recessed

Mount.

10. Proceed to the Wiring Connections section on Page 5 of this

manual.

CONCRETE

3/16" Dia. X 2 1/4" Blue-

Coated Steel Screws (5/32"

pilot hole)