Diamond +7FRED2A0N Manual - Página 8

Procurar online ou descarregar pdf Manual para Fritadeira Diamond +7FRED2A0N. Diamond +7FRED2A0N 15 páginas.
Também para Diamond +7FRED2A0N: Manual do utilizador (15 páginas), Manual de início rápido (15 páginas)

Imprimir página

5.2. ELECTRIC APPLIANCES

5.2.1. ELECTRICAL CONNECTION (Fig. 4A -Table A).

IMPORTANT! Before connecting, make sure the mains

voltage and frequency match that given on the dataplate.

• To access the terminal board, remove the appliance con-

trol panel by removing the fixing screws (fig. 4A 1-2).

• Connect the power cable to the terminal board as shown in the

wiring diagram attached to the appliance.

• Secure the power cable with the cable gland.

IMPORTANT! The manufacturer declines any liability if the

safety regulations are not respected.

5.2.2. POWER CABLE

Unless otherwise specified, our appliances are not equipped with

a power cable. The installer must use a flexible cable having

characteristics at least equivalent to H05RN-F rubber-insulated

type cables. Protect the cable section outside the appliance with a

metal or rigid plastic pipe.

5.2.3. CIRCUIT BREAKER

Install a circuit breaker ahead of the appliance. Contact open-

ing distance and maximum leakage current must comply with

current regulations.

5.3.

EQUIPOTENTIAL NODE AND EARTH

CONNECTION

Connect the appliance to an earth; it must be included in an

equipotential node by means of the screw located at the front

right under the frame. The screw is marked with the symbol

Appliance max. leakage current is 1 mA/kW.

6. SAFETY THERMOSTAT

Some of our appliance models use a safety thermostat that

cuts in automatically when temperatures exceed a set value,

shutting off the gas supply (gas appliances) or the electricity

(electric appliances).

6.1. RESET

• Wait until the appliance has cooled down: a suitable tem-

perature for resetting is approx. 90°C.

• Press the red button on the safety thermostat body.

IMPORTANT! If resetting requires the removal of a protec-

tive part (e.g. control panel) this must be done by a special-

ised technician. Tampering with the safety thermostat invali-

dates the warranty.

7. FUSE REPLACEMENT

The electrical system protection fuse is located inside the

panel. To replace the fuse, unscrew the fuse holder cap and

remove it.

8. BEFORE LEAVING

Check all connection for gas leaks with soap and water. Do

not use a naked flame for detecting leaks. Ignite all burners

both individually and combined to ensure correct operation

of gas valves, burners and ignition. Turn gas taps to low flame

for each burner, individually and separately, when satisfied

with the appliance, please, instruct the user on the correct

method of operation. In case the appliancefails to operate

correctly after all checks have been carried out, refer to the

authorised service provider in your area.