3B SCIENTIFIC PHYSICS 1017895 Folha de instruções - Página 5
Procurar online ou descarregar pdf Folha de instruções para Multímetro 3B SCIENTIFIC PHYSICS 1017895. 3B SCIENTIFIC PHYSICS 1017895 8 páginas. Demo multimeter
Imprimir página5. Symbol legend
Display
Hazard, read instruction sheet
Moving coil galvanometer
Apparatus with electronic amplifier
DC quantities accuracy class 2
AC quantities accuracy class 3
Use in vertical position
Dial position when turned off
Dial position for battery test when bat-
tery charge is satisfactory
Front
Meter on
Meter off
AC measurements
DC measurements
Zero point centre
Zero point left
Battery test
Ground symbol
Rear
EU conformity mark
Earth symbol
Electrical safety assured by double insu-
lation
Do not dispose in normal domestic waste
For use indoors only
Electric fuse
6. Initial calibration
Set up the demo multimeter vertically.
Do not connect measuring leads to begin
with.
Set the toggle switch 1 to
Set the power switch to .
The needle will point to the zero point of the scale
on the left. If it does not, the amount of charge of
the battery should be checked.
7.1 To switch on:
7.2 Checking battery charge:
If the battery is sufficiently charged, the needle
will point to the following range indication,
need to be replaced immediately.
7.3 Zero point calibration:
7.4 Zero point calibration for centre zero
For measurements of DC current and voltage, the
zero point of the scale can be moved to the centre
of the dial. For this purpose the scales are la-
belled with red numbers..
7.5 To switch off:
When the meter is turned off, the needle points to
7.6 If a measurement is interrupted by battery
.
After 45 minutes of use, the multimeter is auto-
matically shut off and the needle will then point to
To switch back on:
5
7. Operation
Set the power switch to .
Turn on the demo-multimeter.
Disconnect all measuring leads.
Set the toggle switch 2 to
Set the rotary switch to
. If this is not the case, the battery will
Turn on the demo-multimeter.
Turn the rotary switch to 600 V.
Connect the common/ground socket and the
voltage measurement socket together by
means of a short connecting lead.
Turn the zero-point trimmer screw to adjust
the zero point as needed.
point:
Turn on the demo-multimeter.
Disconnect all measuring leads.
Set the toggle switch 2 to
Set the toggle switch 1 to
Use the zero-point trimmer to line up the nee-
dle precisely in the centre of the dial (red di-
vision).
Set the power switch to
Set the four-way switch to
.
cut-out:
.
Set the power switch of the multimeter to off
and then use it to turn the meter back on.
.
.
.
.
.
.