Aquasana EQ-1000 Manual do Proprietário - Página 8
Procurar online ou descarregar pdf Manual do Proprietário para Sistemas de filtragem de água Aquasana EQ-1000. Aquasana EQ-1000 16 páginas. Whole house water filter
Também para Aquasana EQ-1000: Manual de instalação (5 páginas), Manual do Proprietário (16 páginas)
Imprimir página
INSTALLATION STEPS
6
5
Install Shut-off Valve and Ensure Spacing
NOTE: DO NOT cut more pipe than necessary. You can cut more pipe later if
needed. If you're also installing a Pro-Install Kit or bypass loop, do so at this time.
Incoming
water supply
Cut Pipes
6
Cut pipe along the marked sections from step
5 and clean ends of pipe. Ensure there are no
burrs, sharp edges or deep scratches.
NOTE: Cut tubing as straight as possible
with a utility knife, or an appropriate
pipe cutter for copper tubing or PVC.
7
Configure System
Fit Rhino tank and additional optional
add-ons into the system at this time.
Screw Pre-Filter support bracket onto
the wall and attach Pre-Filter.
Properly connect system together
accordingly (slip fittings, barbed fittings,
NSF certified PVC glue, etc.). Ensure all
parts are flowing through the "IN" port in
the correct direction of water flow.
8
Final System Check
Once installation is complete, allow proper time for glue to dry according to
manufacturer instructions. Then, slowly turn water on and inspect for leaks.
After inspecting for leaks, turn on the faucet closest to the installed unit
and allow water to run for 5-10 minutes for the final flushing period.
Ensure proper spacing to fit Pre-Filter, Rhino tank,
and any optional add-ons
(Cont. from previous page)
Outgoing
water supply