AquaScape 91006 Instrução e manutenção - Página 7

Procurar online ou descarregar pdf Instrução e manutenção para Bomba de água AquaScape 91006. AquaScape 91006 16 páginas.

Ex. 20

• Install second outer bearing washer over the impeller shaft

(Ex. 22).

• Replace water chamber cover containing the impeller shaft

centering bushing by sliding it over the impeller shaft and

then rotating it clockwise to lock it into place over the tabs

on the pump housing (Ex. 23).

Ex. 22

Winter Application

If concerned about possible freeze damage, disconnect the pump and remove the pump from the water. Clean the pump

with fresh water and store the pump in a frost-free location. The pump can be run during cold weather, if desired, but should

be removed in the event of a power failure to prevent any freeze damage to either the pump or the tubing.

• Reduced water flow

– It may be necessary to clean the filter screen, sponge, and impeller.

• Pump hums but doesn't push water

– It may be necessary to clean the filter screen, sponge, and impeller.

– Remove the water chamber cover and inspect and clean the impeller rotor assembly and internal pump body.

– Make sure nothing is blocking or wrapped around the impeller.

– Make sure the pump is receiving the correct voltage.

• Pump not working

– The ground-fault circuit-interrupter (GFCI) may have tripped.

– The pump is not receiving the correct voltage.

☎

aquascapeinc.com |

CAN (866) 766-3426 |

• Replace the pre-filter

sponge and filter screen

before operating the pump.

Using the pump without

filter screens or sponge may

damage the pump and will

void the warranty (Ex. 24).

Ex. 21

Ex. 23

☎

US (866) 877-6637

Ex. 24