Chrysler TOWN & COUNTRY 2016 Manual do utilizador - Página 14

Procurar online ou descarregar pdf Manual do utilizador para Automóvel Chrysler TOWN & COUNTRY 2016. Chrysler TOWN & COUNTRY 2016 20 páginas.

G E T T I N G S T A R T E D

• If "Unlock All Doors 1st Press" is programmed, all doors and liftgate will unlock when you push

the liftgate button. If "Unlock Driver Door 1st Press" is programmed, only the liftgate will

unlock when you push the liftgate button. To select between "Unlock Driver Door 1st Press"

and "Unlock All Doors 1st Press," refer to the "Electronic Vehicle Information Center (EVIC)"

in your vehicles Owner's Manual on the DVD or "Programmable Features" in this guide for

further information.

• If a Key Fob is detected in the vehicle when locking the vehicle using the power door lock

switch, the doors and liftgate will unlock, and the horn will chirp three times. On the third

attempt, your Key Fob can be locked inside the vehicle.

• After pushing the Keyless Enter-N-Go LOCK button, you must wait two seconds before you

can lock or unlock the vehicle using the door handle. This is done to allow you to check if the

vehicle is locked by pulling the door handle without the vehicle reacting and unlocking.

• If a Keyless Enter-N-Go door handle has not been used for 72 hours, the Keyless Enter-N-Go

feature for that handle may time out. Pulling the deactivated front door handle will reactivate

the door handle's Keyless Enter-N-Go feature.

Lock Or Unlock The Liftgate:

With a valid Passive Entry RKE Key Fob within 5 ft (1.5 m) of the liftgate, cycle the handle to open

the liftgate and pull the liftgate open with one fluid motion.

NOTE:

• All doors will remain locked when the liftgate release handle is pushed regardless of the driver's

door unlock preference setting ("Unlock Driver Door 1st Press" or "Unlock All Doors 1st

Press").

• Refer to "Keyless Enter-N-Go" in "Things To Know Before Starting" located in your Owner's

Manual on the DVD for further information.

KEYLESS ENTER-N-GO — IGNITION

Starting

Perform the following starting procedure with a Remote Keyless Entry (RKE) Key Fob inside the

vehicle:

1. Place the gear selector in PARK or NEUTRAL.

2. While depressing the brake pedal, push the ENGINE START/STOP button once. If the

engine fails to start, the starter will disengage automatically after 10 seconds.

3. To stop the cranking of the engine prior to the engine starting, push the button again.

Stopping

1. Bring the vehicle to a complete stop.

2. Shift the transmission to PARK (P).

3. Push the ENGINE START/STOP button once. The ignition switch will return to the OFF

position.