AquaScape AQUASURGE 2000 Instruções e manutenção - Página 4
Procurar online ou descarregar pdf Instruções e manutenção para Bomba de água AquaScape AQUASURGE 2000. AquaScape AQUASURGE 2000 16 páginas. Skimmer and pondless waterfall vault pump
Também para AquaScape AQUASURGE 2000: Manual (16 páginas)
Imprimir página
SAFETY INFORMATION
WARNING: Risk of electric shock – This pump
has not been approved for use in swimming
pool or marine areas.
WARNING: To provide continued protection
against risk of electric shock, connect to properly
grounded, ground fault circuit interrupter (GFCI)
outlets only, using the following guidelines:
(A) Have a qualifi ed electrician install a properly
grounded receptacle outlet, acceptable for outdoor
use and protected from snow and rain.
(B) Inspect cord before using.
(C) Do not use extension cords.
(D) Any wiring of pumps should be performed by a
qualifi ed electrician to ensure code compliance
and user safety.
(E) Unplug pump at receptacle outlet when not
in use or before removal from pond.
INSTALLATION
• Always operate the pump fully submerged; or if using
in-line ensure a constant source of fresh water. Failure to
do so may overheat the pump and cause it to fail, voiding
the warranty.
• Use only in fully assembled state, paying particular attention
to ensure that both the outer and inner fi lter screens are
attached to the pump. Failure to operate the pump without
the fi lter screen will allow large debris to enter the pump and
cause the pump to fail, voiding the warranty.
• Do not wear loose clothing that may become entangled
in the impeller or other moving parts.
• Keep clear of suction and discharge openings.
DO NOT insert fi ngers in pump with power connected.
• Do not pump hazardous materials or liquids other than
water, such as oil or organic solvents.
• Do not block or restrict discharge.
• Products returned must be cleaned, sanitized, or
decontaminated, as necessary, prior to shipment to
POND SQUAD
INSTALLATION
INSTRUCTIONS
4
(F) To reduce risk of electrical shock, all wiring
and junction connections should be made per local
codes. Requirements may vary depending on usage
and location.
(G) The power cable should be protected at all times to
avoid punctures, cuts, bruises and abrasions.
(H) Never handle power cords with wet hands.
(I)
Do not remove cord and strain relief. Do not connect
conduit to pump.
(J)
Do not use power cable to lift pump.
ensure that employees will not be exposed to health
hazards in handling said material. All applicable laws
and regulations shall apply.
IMPORTANT: Aquascape, Inc. is not responsible
for losses, injury, or death resulting from a failure
to observe these safety precautions, misuse or
abuse of pumps or equipment.
AQUASURGE
• Input Voltage: 120V AC
• Input Frequency: 60 Hz
• Submersible pump
• For outdoor or indoor use
• Thermally protected
• This pump has been evaluated for use with water only
• Input Amps & Wattage: See chart on next page
US 1-866-877-6637 |
CAN 1-866-766-3426 | www.aquascapeinc.com
SPECIFICATIONS
®