Diamond BABYGEL/48 Manual do utilizador - Página 2

Procurar online ou descarregar pdf Manual do utilizador para Congelador Diamond BABYGEL/48. Diamond BABYGEL/48 3 páginas.

Imprimir página

USER S MANUAL - MOD. BABY

PACKAGING: You should have received your refrigerator with the packing materials intact,

please check that the package is not damaged when it is delivered to you. Before removing the

refrigerator from the packing materials, check that the label FRAGILE is legible and that the arrow

points up. Check that the contents have not been damaged during shipping.

The refrigerators are packed at our facility and are delivered to the shipper undamaged and

properly packaged for transport, therefore we disclaim all responsibility for eventual damages

caused during transport.

Please store the packaging in a dry place; these materials will be necessary for shipping the unit to

the factory in case technical assistance is needed (whether under guarantee or not). Please

remember, however, that all of our packing materials are produced in accordance with regulations

both for packaging materials and for recycling purposes.

INSTALLATION: After removing the refrigerator from the packaging materials, leave it in an

upright position for at least 30 minutes, making sure that the various basins are correct for your

needs.

Check that the On/Off button is in the OFF position (O). Make sure that the installation area (work

counter) is not exposed to sources of heat, and that the temperature does not exceed 45°C; the

refrigerator should NEVER BE DIRECTLY EXPOSED to the heating rays originating from ovens.

Leave at least 10 cm of air space in the area of the refrigerator air ventilation system so that it can

function correctly and efficiently.

Please be informed that irregular conditions compromise both the operation and the life-time of the

refrigerator you have purchased (please note that incorrect installation of the unit will invalidate the

guarantee).

Once the refrigerator has been installed, plug the cord into an electric system which has been

installed according to government regulations (with a ground fault circuit breaker, a suitable

grounding system, etc.). For further information regarding this, refer to the technical data on the

identification plate on the machine. Please remember that a faulty power source will irreparably

damage some of the components of the refrigerator, and that damages of this type are not covered

by the guarantee.

Avoid any type of modification to, or tampering with the refrigerator system.

The desk-top refrigerator must normally be installed horizontally; it is however possible to raise the

rear part 5 cm for improved access to the inner basins.

NOTE: IT IS IMPORTANT that the basins be properly cleaned before putting ice cream into

them.

START-UP: Our refrigerators undergo a total of 3 inspections before being sold, therefore they

should be trouble-free; however, if the contrary is true, we truly apologise.

After having correctly installed the unit, proceed with the start-up phase which is as simple as

pushing the green button into the ON position (I), and within 60 seconds the refrigerator will start-

up.

Once the system is operating, a maximum of 4 hours is required for the unit to come up to the

factory set temperature of -18°C. If you would like to change the temperature setting,

simultaneously press the SET button for 5 seconds : the SET POINT temperature shows up and

start to flash. Push the Up Arrow to raise the temperature, or the Down Arrow button to lower

the temperature and press again SET to confirm the change.

Remember that our counter top refrigerators maintain the temperature inside the food bins rather

than lowering the temperature, and therefore the food products should not be placed into the basins

until they have reached the proper temperature.