Panasonic WV-SW395 Manual de instalação - Página 27

Procurar online ou descarregar pdf Manual de instalação para Câmara de vídeo Panasonic WV-SW395. Panasonic WV-SW395 40 páginas. Ip video cameras
Também para Panasonic WV-SW395: Especificações (2 páginas), Brochura (2 páginas), Gráfico de comparação (6 páginas), Manual de instalação (40 páginas), Manual de instalação (40 páginas), Nota de integração (8 páginas)

Initialize the camera

Use the initial set switch to reset the settings of the camera to the default.

Important:

• The settings including the network settings will be initialized. Note that the preset position settings and the CRT key

(SSL encryption key) used for the HTTPS protocol will not be initialized.

Step 1

Open the SDHC/SD memory card slot cover by following

steps 1 - 3 of the "How to insert an SDHC/SD memory

card" section (☞ page 15).

Step 2

Move the initial set switch to the right (ON).

The factory default is OFF.

Step 3

Move the Initial set switch to the right, and then turn on

the power of the camera. The camera will start up and all

the settings including the network settings will be initial-

ized. The initialization will be complete when the live indi-

cator stops blinking orange and lights off. Before initializ-

ing the settings, it is recommended to write down the set-

tings in advance.

Important:

• Do not turn off the power of the camera during initial-

ization. Otherwise, it may fail to initialize and may

cause malfunction.

Step 4

Turn off the power of the camera.

Live indicator

Initial set switch

(Right: ON, Left: OFF)

Step 5

Move the Initial set switch to the left (OFF).

Important:

• If the Initial set switch is positioned to the "ON" side,

the camera cannot enter the normal operation mode.

Be sure to return the Initial set switch to the "OFF"

position.

Step 6

Return the parts to the original state by following steps 5 -

7 of the "How to insert an SDHC/SD memory card" sec-

tion (☞ page 15).

Step 7

Turn on the power of the camera. (☞ Page 12)

• When the power is supplied, the camera will enter the

normal operation mode.