Diamond Antenna K9000 Instruções de funcionamento - Página 3
Procurar online ou descarregar pdf Instruções de funcionamento para Acessórios para automóveis Diamond Antenna K9000. Diamond Antenna K9000 4 páginas. Motor drive mount
Imprimir páginaExplanation of Operation
Warning
* The back torque limiter contained on this mount bracket
can work only when the limit switch is ON in response to
raising an antenna. For this reason, backlash shall be avoided.
The position of installation should not be reversed. Change
the direction of the mount bracket body if you want to lower
the antenna to the reverse direction.
1. Trunk/Hatchback (K9000TM Mount Bracket)
Installing K9000TM Mount Bracket on Car
• Choose desired mounting location to ensure strength of mount,
best performance of antenna, and proper opening and closing of
trunk/hatchback.
• Slide mounting bracket over lip edge of trunk/hatchback.
Fasten mounting set screws using enclosed metal protection plate
between screws and vehicle. Install antenna. (See recommended
antennas for proper antenna selection.)
• Proper angle adjustment on trunk/hatchback installations:
Loosen mount bolt and turn mount
laterally.
Raise and adjust the mount bracket
body horizontally.
2. Roof Rail/Carrier Pipe (K9000LRM Mount Bracket )
Installing K9000LRM Mount Bracket on Car
Example of installation
on outside roof rail.
Example of installation
inside roof rail.
• K9000LRM mount bracket can be installed on round and
square pipes or rails.
Dimensions of pipes and roof rails
K9000LRM mount bracket can be installed on various pipes
and roof rails by adjusting fitments as shown. Install antenna.
(See recommended antennas for proper antenna selection.)
Round Pipe in diameter of 15-34
Square Pipe in one side of 15-26 mm
Roof Rail in height of less than 32 mm and width of
less than 50 mm
3
Loosen the set screws on bottom
of mount bracket body. Turn
the mount bracket laterally to adjust
direction of antenna's "down"
position. If you want to turn more than
50 degrees, detach the mount bracket
and parts, and then adjust.
* If proper angle adjustment is not
possible due to contact between the
mount bracket and the car body, move
installation to different location while
maintaining proper raise/lower direction.
Protection Sheet