Panasonic AP364 Manual de serviço - Página 12

Procurar online ou descarregar pdf Manual de serviço para TV Panasonic AP364. Panasonic AP364 48 páginas. Color television

Imprimir página

Purity Adjustment

When the Receiver is in the Service Mode for making

electronic adjustments, press the Recall button on the

Remote Control to enter Purity Check. (See the

Service Adjustments Electronic Controls procedure).

Operate the Receiver for 60 minutes using the first

Purity Check field (white screen) to stabilize the CRT.

Fully degauss the Receiver by using an external

degaussing coil.

Press the Recall button on the Remote Control again

until the Purity Check (green screen) appears.

For a 2-piece assembly

Loosen the deflection yoke clamp screw and move the

deflection yoke back as close to the purity magnet as

possible.

Adjust the Purity rings to set the vertical green raster

precisely at the center of the screen (see Fig. 10).

Figure 10. Green Raster Adjustment

Slowly move the deflection yoke forward until the best

overall green screen is displayed.

For a 1-piece assembly

Slowly move the deflection yoke and purity rings

assembly toward the CRT board and adjust the purity

magnet rings to set vertical green raster at center of

screen (see Fig. 10).

Gradually move the deflection yoke & purity rings

forward and adjust for best overall green screen.

Continue from here for either assemblies:

Tighten the deflection yoke clamp screw.

Press the Recall button on the Remote Control again

until the purity check (blue screen) and (red screen)

appear and observe that good purity is obtained on

each respective field.

Press the Recall button on the Remote Control again

until Purity check (white screen) appears. Observe the

screen for uniform white. If purity has not been

achieved, repeat the above procedure.

(see Fig. 5)

(see Fig. 8)

- 12 -

Final Convergence Procedure

through Fig. 13)

Note: Vertical size and focus adjustments must be

completed prior to performing the convergence

adjustment. Connect a dot pattern generator to

the Receiver. The Brightness level should not

be higher than necessary to obtain a

clear pattern.

Converge the red and the blue dots at the center of the

screen by rotating the R & B pole Static Convergence

Magnets.

Align The converged red/blue dots with the green dots

at the center of the screen by rotating the R & B & G

pole Static Convergence Magnets. Melt wax with

soldering iron to reseal the magnets.

Slightly tilt vertically and horizontally (do not rotate) the

deflection yoke to obtain a good overall convergence.

If convergence is not reached at the edges, insert

permalloy (see following section) from the DY corners

to achieve proper convergence. Recheck for purity and

readjust if necessary.

After vertical adjustment of the yoke, insert wedge at 11

o'clock

position,

then

adjustment.

Secure the deflection yoke by inserting two side

wedges at 3 and 7 o'clock positions.

Apply adhesive between tab (thin portion) of wedge

and CRT and place tape over the tab to secure to the

CRT.

Permalloy Convergence Corrector Strip (Part

No. 0FMK014ZZ)

This strip is used in some sets to match the yoke and

CRT for optimum convergence. If the yoke or CRT is

replaced, the strip may not be required.

First converge the set without the strip and observe the

corners.

If correction is needed:

1. Place strip between CRT and yoke, in quadrant

needing correction. Slowly move it around for

desired results.

2. Press adhesive tightly to the CRT and secure

with tape.

(see Fig. 11

make

the

horizontal

tilt