Panasonic CT-31SF20R Manual de Instruções - Página 5

Procurar online ou descarregar pdf Manual de Instruções para TV Panasonic CT-31SF20R. Panasonic CT-31SF20R 44 páginas.

Imprimir página
Installation
Location
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the
screen.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or
moisture. Do not position magnetic equipment (motors, fans, other speakers, etc.) nearby.
Optional External Equipment Connections
The Video/Audio connections between components can be made with shielded video and audio cables. For best per-
formance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic
supply house.
Before you purchase any cables, be sure you know what type of output and input connectors your various components
require. Also determine the length of cable you'll need.
AC Power Supply Cord
Insert (Polarized) plug into 120 volts 60Hz standard
AC outlet. Do not defeat the safety
purpose of the polarized plug.
CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED)
PLUG
WITH AN EXTENSION
CORD, RECEPTACLE
OR OTHER OUTLET
UNLESS THE
BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
Polarized Plug
Remote Control Battery Installation & Replacement
_
-
Battery Installation
"
.c,..E
Batteries: Use two "AA" batteries.
1.
Turn the Transmitter face up. To remove bottom cover, press down on
marking and slide cover off in the direction indicated.
2.
Install the batteries a.Sshown in the battery compartment. (Polarity (+) or
(-) must be correct.)
3.
Replace the cover and slide in reverse until the lock snaps.
Precaution
on Battery
Use
Incorrect installation can cause battery leakage and corrosion that will
damage the Remote Control Transmitter.
Observe the Following Precautions:
1.
Batteries must be replaced as a pair.
2.
Do not combine a used battery with a new one.
3.
Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").
4.
Do not attempt to charge , short-circuit, disassemble, heat, or burn used
batteries.
5.
Battery replacement is necessary when Remote Control reacts
sporadically or stops operating the Receiver or optional equipment.
Loss of programmed infra-red codes for VCR and Cable Converter
buttons will result when battery power is completely depleted, batteries
are removed for more than several minutes, or pressing any Remote
Control button while batteries are removed.
FREEZE
SEARCH
SWAP
PIP
(Z) C=)0
0
AUmO
SIZE
SWAP
!2D
CD
PressDOwn HereTo
ide CoverBack
-5-