Diamond Audio Technology D7056 Manual de instalação

Procurar online ou descarregar pdf Manual de instalação para Amplificador para automóvel Diamond Audio Technology D7056. Diamond Audio Technology D7056 11 páginas.

Imprimir página

LOWPASS ON/OFF

Pushing this button "IN" engages the Lowpass filter. Pushing this button

"OUT" will bypass the filter.

LOWPASS FREQUENCY

Turning this control sets the Lowpass crossover point from 50Hz (fully

counterclockwise) to 5kHz (fully clockwise).

HIGHPASS FREQUENCY

Turning this control sets the Highpass crossover point from 50Hz (fully

counterclockwise) to 5kHz (fully clockwise).

HIGHPASS ON/OFF

Pushing this button "IN" engages the Highpass filter. Pushing this button

"OUT" will bypass the filter.

Note: By engaging both Highpass and Lowpass filters and setting the desired

crossover points, a Bandpass filter can be created:

D7 CROSSOVER FREQUENCIES

Diamond Audio D7 Professional Reference Series Amplifiers feature fully

variable crossovers. The frequency control knobs (located in the tray on the

top of the amplifier) are labeled 50Hz when the knob is rotated fully counter-

clockwise (left) and 5kHz when rotated fully clockwise (right).

To make basic setting of the crossover frequencies a little easier, we've

come up with the following rotational diagram:

HIGHPASS/LOWPASS

FREQUENCY

Notice that the outer most circle of numbers (1:00, 2:00, etc.) represent

numbers as they appear on the face of a clock. The number underneath each

"hour" designation on the simulated clock face is the approximate crossover

frequency at that position.

BRIDGING

All pairs of Diamond Audio D7 amplifier channels are capable of being

bridged to a 4 Ohm mono output. Creation of the mono channel is accomp-

lished by using the left channel positive (+) output connection of the amplifier

for the speaker positive and the right channel negative (-) output connection

of the amplifier for the speaker negative.

Example: Two 8 ohm Woofers Wired In Parallel = 4 ohm Bridged Impedance.

Note: It is important that a 4 Ohm minimum total speaker impedance load is

observed! If an impedance load of less than 4 Ohms is used, you will

eventually damage your amplifier and void your warranty.

RCA INPUTS AND OUTPUTS

The D7056 Professional Reference Amplifier features 3 pairs of stereo input

RCA jacks. Each pair of amplifier channels can be driven separately or they

can be combined in a number of different ways. This amplifier IS NOT

equipped with an AUXILIARY Crossover.