Diamond Audio Technology CM341 Manual do Proprietário - Página 6
Procurar online ou descarregar pdf Manual do Proprietário para Altifalantes para automóvel Diamond Audio Technology CM341. Diamond Audio Technology CM341 10 páginas. Cm3 series convertible speaker systems
Flush Tweeter Mounting
1. Remove tweeter from bridge follow-
ing bridge disassembly instructions.
2. Cut a 1.625" diameter hole in desired
location. (make sure it is a flat sur-
face)
3. Insert Flush mount cup screw through
center hole in flush mount cup.
4. Twist flush mount cup spring onto
screw.
5. Push entire assembly through hole cut
earlier and tighten flush mount screw
till cup is held firmly in place by the spring.
6. "Snake" tweeter leads through the wire holes in the cup.
7. Snap tweeter into cup by aligning the notches on the tweeter with the
tabs in the cup. (do not push on the center of tweeter grill)
8. Attach provided tweeter speaker wire to tweeter leads taking note of
polarity. (wire w/ white stripe is positive)
Crossover Detachment
(for remote crossover mounting in component systems)
1. Remove screw located at the bottom of
the crossover.
2. Gently remove crossover by pulling
downward.
3. Mount crossover to wire harness or some
stable location using provided zip tie.
1. To reattach, line up terminal holes on
crossover with terminals on the mid bass
speaker and gentle push upwards.
2. Replace crossover mounting screw and
tighten. (do not over tighten)
Mounting
Spring
Clip
Coaxial Wiring
1. Mount bridge to mid bass following
the bridge mounting instructions.
1. Connect speaker wire from source to
terminals on crossover (already
mounted on speaker) and play.
Cup
(align tab and slot)
Tweeter
Screw