Panasonic DMC-FH10P Manual de serviço - Página 31

Procurar online ou descarregar pdf Manual de serviço para Câmara digital Panasonic DMC-FH10P. Panasonic DMC-FH10P 38 páginas.
Também para Panasonic DMC-FH10P: Manual do Proprietário (2 páginas)

Imprimir página

9.3.1.3.

Execute Adjustment

(In case of "OIS Adjustment")

1. Perform step "9.3.1.1." to "9.3.1.2.", to reset the OIS flag

status "F" (Set) to "0" (Reset)

2. Press "[ W ] side of the Zoom button" after Flag reset.

OIS Adjustment screen is displayed on the LCD panel.

(Refer to Fig.3-3)

3. Press the [ Shutter ] button.

The adjustment will start automatically.

4. When the adjustment is completed successfully, adjust-

ment report menu appears with Green OK on the LCD

monitor. (Refer to Fig.3-4)

9.3.1.4.

Attention point during Adjustment

1. Step "9.3.1.3." procedure shows OIS adjustment as an

example. To perform the adjustment, refer to the "9.3.2.

Adjustment Specifications" table which shows key point

for each adjustment.

2. Do not move the light box, the camera or the chart while

adjusting. If one of these is moved accidentally, start the

adjustment again.

3. Do not press any buttons/keys until the default menu

(Refer to Fig.3-5) is displayed on the LCD monitor. Other-

wise, adjustment data may not be stored properly.

4. If the adjustment is interrupted accidentally, the alignment

data may not be properly saved in the Flash-ROM.

9.3.1.5.

Finalizing the Adjustment

1. Several adjustment flags can be reset ("F" into "0") at the same time. In this case, when the adjustment has been completed,

the screen will change showing the adjustment for the next item until all reset items are completed.

Also, when the [ Shutter ] button is pressed, the screen jump to the next adjustment item.

2. To cancel the adjustment mode while in the process of performing the adjustment, follow this procedures.

3. Operate the following, when escaping the Electrical Adjustment mode on the way.

(1) Press "[ Delete/Cancel ] button".

(2) Press "[ RIGHT ] of Cursor button".

NOTE:

• If adjustment is cancelled with above procedure, adjustment is not completed. Make sure to adjust it later.

• Adjustment software "DIAS" is able to control the status of the adjustment flags.

Fig.3-3

Fig.3-4

Fig.3-5