HP 1405-8 Manual de instalação e de iniciação - Página 20
Procurar online ou descarregar pdf Manual de instalação e de iniciação para Interruptor HP 1405-8. HP 1405-8 45 páginas. 1405 switch series
Também para HP 1405-8: Manual de início rápido (16 páginas), Manual de instalação e de iniciação (44 páginas)
Imprimir página
C a u t i o n
LED Behavior
After Initialization:
The Power LED remains on.
•
The port Link/Act LEDs on the front of the switch go into their normal
•
operational mode:
–
If the ports are connected to active network devices, the Link/Act
LEDs stay on or may be blinking to indicate port activity.
–
If the ports are not connected to active network devices, the
Link/Act LEDs will stay off.
If the LED display is different than what is described above, the self test
has not completed correctly. Refer to chapter 4,
diagnostic help.
3. Mount the Switch
After the switch passes self test, it is ready to be mounted in a stable location.
The switch can be mounted in these ways:
■
on a horizontal surface
■
on a wall
Wall Mounting
You can mount the switch on a wall. A special kit for wall mounting is included
with the switch.
The switch should be mounted only to a wall or wood surface that is at least
1/2-inch (12.7 mm) plywood or its equivalent.
1.
In the required location, mark the position for the mounting screws.
2.
Use a Phillips #2 (cross-head) screwdriver and two of the included
∅ 3.5mm tapping screws to mount the switch on the wall or wood surface.
Screws and wall anchors are included in the accessory kit for use with
plastered brick or concrete walls.
Installing the Switch
Installation Procedures
"Troubleshooting"
for
2-8