HP 1910-8-PoE+ Manual de iniciação - Página 22

Procurar online ou descarregar pdf Manual de iniciação para Interruptor HP 1910-8-PoE+. HP 1910-8-PoE+ 26 páginas. 1910 switch series
Também para HP 1910-8-PoE+: Especificação rápida (43 páginas), Ficha de dados (16 páginas), Especificação rápida (44 páginas)

Imprimir página

............................................................................

........................................................Done!

System application is starting...

User interface aux0 is available.

Press ENTER to get started.

Press Enter and the system displays the following prompt:

<Hp>

This prompt indicates that the switch is ready to configure.

Appendix A Troubleshooting

This chapter lists some issues that you may encounter while using and managing the switch, with

corrective action to take.

If you encounter an issue that is not listed here and you cannot solve it, please contact your local

technical support representative.

Table 4 Troubleshooting

Symptom

Power LED off

LAN interface LED off

Troubleshooting method

Verify that the correct power source is used and the power cords are

properly connected.

Verify that the power source side provides power supply normally.

Verify that the network cable is properly connected to the network

port of the switch.

Plug the two ends of a network cable into two network ports of the

switch. If the port LEDs are on, it indicates that the network cable is

well. Otherwise, please replace the network cable.